PIC16F946-I/PT - 20MHz 8-Bit Flash MCU | Microchip Technology
MPN: PIC16F946-I/PT ✓ چالاکPIC16F946-I/PT گشتی
A microcontroller is a programmable semiconductor that integrates a processor core, memory, and peripherals into one package. The PIC16F946 belongs to the PIC16 family of 8-bit CMOS microcontrollers, a category commonly used for embedded control, human-interface, instrumentation, and low-to-medium-speed automation systems. Its dedicated LCD-driver outputs reduce external display-controller requirements in applications using segmented or dot-matrix LCDs.
The PIC16F946-I/PT provides up to 168 LCD segments, an internal oscillator spanning 32 kHz to 8 MHz, and two 8-bit timers plus one 16-bit timer. The extended watchdog timer supports reliable recovery from unexpected program flow, while brown-out reset provides controlled startup when the supply voltage falls below its operating threshold. A 64-pin TQFP package provides broad I/O availability while supporting a 2.0 V to 5.5 V operating-voltage range.
According to the Microchip PIC16F946 manufacturer datasheet 41265A, the controller uses a Harvard-style architecture with flash program memory and data memory, executes its instruction set in as little as 200 ns, and includes an instruction set described as 35 single-word instructions. In-Circuit Serial Programming allows firmware programming and debugging without removing the device from its circuit, accelerating prototype bring-up and production programming.
Typical uses include digital panel meters, industrial measurement equipment, environmental monitors, pump and valve controllers, and compact consumer appliances. Its LCD driver is particularly useful in human-interface equipment requiring multiple alphanumeric or graphical indicators. The internal oscillator also allows designs to start without a separate crystal when precision beyond the internal clock range is unnecessary.
Designers should verify the LCD segment mapping, oscillator tolerances, and timing requirements in the manufacturer datasheet before layout release. Place decoupling capacitors close to the supply pins, reserve a programming interface for In-Circuit Serial Programming, and confirm that the selected crystal or external clock remains compatible with the intended operating frequency.
This product page combines device specifications, qualified replacement guidance, comparison parameters, and practical implementation notes to support faster component selection and PCB planning.
جێگرەوەکانی جێگۆڕکێ بۆ PIC16F946-I/PT — هەمان پاکەت، پین بە پین گونجاو. ئەو بەشانەی پاکەتی جیاوازیان هەیە و پێویستیان بە چاککردنەوەی PCB هەیە لابراون.
جۆرەکان لەم زنجیرەیەدا
مۆدێلەکانی هەمان زنجیرە کە بە شێوەی ڕاستەوخۆ گونجاون لەگەڵ PIC16F946-I/PT (هەمان شێوە و پێکهاتەی شوێن) — جیاوازە لە Package, LCD Driver, Operating Temperature, Timers, Program Memory Type.
PIC16F946T-I/PT
✅ جێگرەوەی ڕاستەوخۆ📋 جێگرەوەی سەرچاوە (لە کاتالۆگدا نییە)
PIC16F946-E/PT
✅ جێگرەوەی ڕاستەوخۆپەیوەندی بۆ نرخ
بینینی داتاشیت →PIC16F946-I/PT زۆرترین ڕێژە و تایبەتمەندییە کارەباییەکان
| Microcontroller Type | 8-bit CMOS flash-based PIC microcontroller |
| Maximum Operating Frequency | 20 MHz |
| Program Memory | 14 KB flash (8K x 14 words) |
| Data RAM | 352 bytes |
| پاکێج | 64-pin TQFP (10 mm x 10 mm) |
| Operating Voltage Range | 2.0 V to 5.5 V |
| Internal Oscillator Range | 32 kHz to 8 MHz |
| LCD Segment Support | Up to 168 segments |
| I/O Source/Sink Current | 25 mA |
| Timer Count | Two 8-bit timers and one 16-bit timer |
| Watchdog Timer | Extended Watchdog Timer (EWDT) |
| Brown-Out Reset | Supported with software control |
| Programming Interface | In-Circuit Serial Programming (ICSP) |
| Instruction Execution Time | 200 ns minimum |
| Instruction Set | 35 single-word instructions |
| Architecture | Harvard-style PIC RISC architecture |
| جۆری دامەزراندن | Surface mount |
ڕێنمایی ڕێکخستنی پینی PIC16F946-I/PT 64-pin tqfp (10 mm x 10 mm)
ڕێکخستنی پین بۆ PIC16F946-I/PT (پاکێجی 64-pin tqfp (10 mm x 10 mm)). ئەم IC ی دیجیتاڵە GPIO، ڕووکارەکانی پەیوەندی (UART، SPI، I2C) و پینی وزە لەخۆدەگرێت. سەرنج بدە بە داتاشیتی بەرھەمھێنەر بۆ فەنکشنەکانی پینی جێگرەوە و ھەڵبژاردنەکانی ڕێکخستن. پێویستە بۆ دیزاینی سیستەمی جێگیر و ڕێکخستنی PCB.
هیچ داتای وردی پینئاوت بەردەست نییە بۆ PIC16F946-I/PT.
سەرنج بدە بە داتاشیت بۆ ڕێکخستنی تەواوی پینەکان.
بەکارهێنانە باوەکان
PIC16F946-I/PT گونجاوە بۆ 6 بەکارھێنانs: Digital Panel Meter, Industrial Measurement Instrument, Environmental Monitor, Pump and Valve Controller, Programmable Logic Controller, Battery-Powered Sensor Interface.
Digital Panel Meter
The PIC16F946-I/PT fits digital panel meters because its integrated LCD driver supports up to 168 segments while the 20 MHz processor provides responsive measurement updates and menu handling. The 14 KB flash area can hold calibration tables, display routines, and communication firmware, while 352 bytes of RAM supports working variables and display buffers. Using the internal 32 kHz-to-8 MHz oscillator can also reduce external clock components when moderate timing accuracy is acceptable.
پێشنیارکراو
Industrial Measurement Instrument
For industrial measurement instruments, the PIC16F946-I/PT combines flash program memory, three timers, an extended watchdog timer, and 25 mA I/O source/sink capability in a compact 64-pin TQFP. A 200 ns minimum instruction execution time supports responsive signal acquisition and control, while the 2.0 V to 5.5 V range accommodates regulated industrial rails. Brown-out reset improves controlled recovery during supply disturbances that are common around motors and switching loads.
پێشنیارکراو
Environmental Monitor
The PIC16F946-I/PT suits environmental monitoring systems that periodically acquire sensor data, apply calibration, and display results on an LCD. Its timer resources can organize sampling intervals, while the internal oscillator permits low-cost timing implementations from 32 kHz through 8 MHz. The LCD driver removes the need for a separate display controller, and the extended watchdog timer helps recover routine operation if a sensor or communication path stalls.
پێشنیارکراو
Pump and Valve Controller
The PIC16F946-I/PT is appropriate for compact pump, valve, and actuator-control boards where multiple discrete I/O lines are required around a local display and operator interface. Its 64-pin TQFP provides greater I/O density than smaller controller packages, and the dedicated 16-bit timer can support accurate timing intervals alongside the two 8-bit timers. The watchdog and brown-out protections help maintain deterministic behavior during transients and firmware faults.
پێشنیارکراو
Programmable Logic Controller
The PIC16F946-I/PT can serve as the control core of a compact programmable logic controller for machine interfaces, sequencers, and distributed I/O. Flash memory supports field-updatable logic, and the 20 MHz operating ceiling allows the processor to coordinate multiple timers, inputs, and outputs. The 64-pin package leaves dedicated interface capacity for sensors and actuators, while In-Circuit Serial Programming simplifies firmware maintenance without board removal.
پێشنیارکراو
Battery-Powered Sensor Interface
The PIC16F946-I/PT works well in battery-powered sensor interfaces that need periodic processing, local indication, and low-power control between measurements. Its internal oscillator range begins at 32 kHz, allowing a low-frequency operating mode, while the 2.0 V minimum operating voltage supports regulated low-voltage rails. The integrated LCD driver can present status information without continuously energizing a separate display controller, although average-current calculations should include LCD and peripheral duty cycles.
پێشنیارکراو
کورتەی بەرهەمە پێشنیارکراوەکان
داتای سەرچاوەی ئەندازیاری بۆ PIC16F946-I/PT — بەراوردکردن، ڕێنمایی دیزاین و زانیاری پابەندبوون.
ڕێنمایی هەڵبژاردن
بەراوردکردن لەگەڵ جێگرەوەکان
| پارامەتر | ئەم بەرهەمە | PIC16F946T-I/PT | PIC16F946-E/PT |
|---|---|---|---|
| Package | 64-pin TQFP (10 mm x 10 mm) | 64-pin TQFP (10 mm x 10 mm) | 64-pin TQFP (10 mm x 10 mm) |
| Brand | Microchip Technology | Microchip Technology | Microchip Technology |
| Processor Architecture | 8-bit PIC RISC | 8-bit PIC RISC | 8-bit PIC RISC |
| Maximum Operating Frequency | 20 MHz | 20 MHz | 20 MHz |
| Program Memory | 14 KB flash (8K x 14 words) | 14 KB flash (8K x 14 words) | 14 KB flash (8K x 14 words) |
| Data RAM | 352 bytes | 352 bytes | 352 bytes |
| Operating Voltage Range | 2.0 V to 5.5 V | 2.0 V to 5.5 V | 2.0 V to 5.5 V |
| LCD Segment Support | Up to 168 segments | Up to 168 segments | Up to 168 segments |
| Temperature Grade | I-grade industrial temperature | I-grade industrial temperature | E-grade extended temperature |
| Programming Interface | In-Circuit Serial Programming (ICSP) | In-Circuit Serial Programming (ICSP) | In-Circuit Serial Programming (ICSP) |
جیاکەرەوە سەرەکییەکان
- Closest identified ordering replacement (بەراورد بەPIC16F946T-I/PT)
- Integrated display control reduces external circuitry (بەراورد بەPIC16F946-E/PT)
- Industrial-grade ordering option (بەراورد بەPIC16F946-E/PT)
تێبینییەکانی دیزاین
Place the input and ground decoupling capacitors immediately adjacent to the corresponding power pins, following the pin-description and layout guidance in Microchip datasheet 41265A. Route the LCD segment outputs directly toward the display connector while keeping them away from switching nodes and high-current actuator traces. The 64-pin TQFP footprint also needs unobstructed access around its perimeter for assembly inspection and rework.
Design the supply path for the documented 2.0 V to 5.5 V operating range and include brown-out-reset configuration appropriate to the load. If the internal 32 kHz-to-8 MHz oscillator performs timekeeping or communication, verify whether its accuracy is sufficient; otherwise reserve the external oscillator pins shown in the datasheet. Add filtering where long sensor cables can inject noise into adjacent I/O pins.
Do not substitute an E-grade ordering code when the finished product requires the full I-grade environmental range. Likewise, treat PIC16F946T-I/PT as a candidate only after confirming the manufacturer ordering code and production marking. The target uses In-Circuit Serial Programming, so the PCB should preserve the programming connector and required signal paths for firmware loading and field maintenance.
زانیاری پابەندبوون
The manufacturer product page and datasheet do not state the requested compliance fields in the cited text. No automotive qualification is claimed for this industrial-temperature ordering code.