LM358WPT vs NE5532AP Comparison
Detailed side-by-side comparison of LM358WPT by ROHM Semiconductor and NE5532AP by Texas Instruments. Compare key specifications, electrical parameters, packaging, lifecycle status, pricing, and availability to determine the best component for your design requirements.
Texas Instruments
NE5532AP - Dual Low-Noise Op Amp, 10MHz, 8-PDIP | Texas Instruments
NE5532AP ✓ ActiveSpecification Comparison
| Parameter | LM358WPT | NE5532AP |
|---|---|---|
| Brand | ROHM Semiconductor | Texas Instruments |
| Category | Amplifier ICs | Amplifier ICs |
| Lifecycle Status | Active | Active |
| Number of Amplifiers | 2 amplifiers | — |
| Amplifier Type | General-purpose operational amplifier | Low-Noise Operational Amplifier |
| Nominal Supply Voltage | 5 V | — |
| Single-Supply Operating Range | 3 V to 36 V | — |
| Split-Supply Operating Range | +/-16 V | — |
| Gain-Bandwidth Product | 1.1 MHz | — |
| Small-Signal Bandwidth | 800 kHz | — |
| Slew Rate | 0.3 V/us | [DATA_NEEDED: slew rate V/us] |
| Package | 8-pin TSSOP | — |
| Mounting Type | Surface mount | Through-Hole (PDIP) |
| Number of Inputs | 4 differential inputs | — |
| Number of Outputs | 2 outputs | — |
| Compensation | Internally compensated | — |
| Input Common-Mode Range | [DATA_NEEDED: input common-mode voltage range] | — |
| Output Swing | [DATA_NEEDED: output voltage swing] | — |
| Input Offset Voltage | [DATA_NEEDED: input offset voltage] | — |
| Input Bias Current | [DATA_NEEDED: input bias current] | — |
| Quiescent Current | [DATA_NEEDED: supply current per amplifier] | — |
| Output Current Capability | [DATA_NEEDED: output source and sink current] | — |
| Operating Temperature Range | [DATA_NEEDED: operating temperature range] | 0 °C to +70 °C (NE5532x commercial) |
| RoHS Compliance | [DATA_NEEDED: RoHS compliance status] | — |
| REACH Compliance | [DATA_NEEDED: REACH compliance status] | — |
| Manufacturer | — | Texas Instruments |
| Part Number | — | NE5532AP |
| Number of Channels | — | 2 (Dual) |
| Package / Case | — | 8-PDIP (through-hole, 2.54 mm pitch) |
| Supply Voltage (Dual) | — | ±5 V to ±15 V (max ±18 V) |
| Unity-Gain Bandwidth | — | 10 MHz (typ.) |
| Equivalent Input Noise Voltage | — | 5 nV/√Hz (typ. at 1 kHz) |
| Common-Mode Rejection Ratio (CMRR) | — | 100 dB (typ.) |
| DC Voltage Gain | — | 100 V/mV (typ., 100 dB) |
| Peak-to-Peak Output Swing | — | 32 V typ. (VCC± = ±18 V, RL = 600 ohm) |
| Output Drive | — | 600 ohm loads (typ.) |
| Input Protection | — | Input-protection diodes |
| Output Protection | — | Output short-circuit protection |
| RoHS Status | — | Compliant (Pb-free) |