SP485E vs MAX485ESA+T Comparison
Detailed side-by-side comparison of SP485E by MaxLinear and MAX485ESA+T by Analog Devices. Compare key specifications, electrical parameters, packaging, lifecycle status, pricing, and availability to determine the best component for your design requirements.
MaxLinear
SP485E - Enhanced Low Power Half-Duplex RS-485/RS-422 Transceiver | MaxLinear
SP485E ✓ ActiveSpecification Comparison
| Parameter | SP485E | MAX485ESA+T |
|---|---|---|
| Brand | MaxLinear | Analog Devices |
| Category | Interface ICs | Interface ICs |
| Lifecycle Status | Active | Active |
| Function | Transceiver | — |
| Protocol | RS-485, RS-422 | — |
| Number of Drivers/Receivers | 1/1 | — |
| Duplex | Half-duplex | — |
| Data Rate | 2.5 Mbps (max, SP485E non-slew-limited) | — |
| Supply Voltage (VCC) | 4.75 V to 5.25 V | — |
| Receiver Input Sensitivity | ±200 mV | [DATA_NEEDED: receiver input sensitivity] |
| Receiver Input Impedance | 12 kΩ minimum, 15 kΩ typical | — |
| Common-Mode Range | −7 V to +12 V | — |
| ESD Protection (HBM) | ±15 kV | — |
| ESD Protection (IEC 61000-4-2 Air Discharge) | ±15 kV | — |
| Operating Temperature Range | [DATA_NEEDED: operating temperature] | [DATA_NEEDED: operating temperature range] |
| Package | 8-pin NSOIC or PDIP | 8-pin SOIC |
| Mounting Type | Surface Mount (NSOIC) or Through-Hole (PDIP) | Surface mount |
| Process Technology | BiCMOS | — |
| Failsafe Receiver | Yes (open, shorted, idle bus) | — |
| Tri-State Enable Pins | Yes (DE, RE) | — |
| RoHS Status | Compliant | unknown |
| Product Type | — | RS-485/RS-422 transceiver |
| Transceiver Configuration | — | 1 driver and 1 receiver |
| Operating Mode | — | Half-duplex |
| Supply Voltage Range | — | 4.75 V to 5.25 V |
| Maximum Data Rate | — | 2.5 Mbps |
| Slew Rate Limiting | — | Not limited |
| Driver Short-Circuit Protection | — | Current limited and protected |
| Supported Standards | — | RS-485 and RS-422 |
| Package Pin Count | — | 8 pins |
| Supply Current | — | [DATA_NEEDED: supply current] |
| Driver Output Current | — | [DATA_NEEDED: driver output current] |
| Common-Mode Voltage Range | — | [DATA_NEEDED: common-mode voltage range] |
| ESD Protection | — | [DATA_NEEDED: ESD protection rating] |
| REACH Status | — | unknown |
| AEC-Q100 Qualification | — | unknown |