PIC10F204-I/P
PIC10F204-I/P - 8-Bit 4 MHz Flash Microcontroller | Microchip
The Microchip Technology PIC10F204-I/P is a low-cost, fully static, 8-bit, Flash-based CMOS microcontroller with a 4 MHz performance level, 384 bytes of program memory, and four I/O pins in an 8-pin PDIP package. According to the manufacturer product page, its RISC architecture contains 33 single-word instructions; most execute in one cycle, while program branches require two cycles. The part combines compact code storage with deterministic execution for embedded control tasks.
An 8-bit microcontroller is a programmable semiconductor that executes firmware and manages digital inputs, outputs, timers, and other peripherals. PIC10F204-I/P belongs to the Microchip PIC10F family, which sits within the broader hierarchy of embedded microcontroller, embedded processor, and semiconductor product categories. Its fully static operation permits the processor to remain in a stable low-activity state when clocking is stopped, depending on the device configuration.
Verified distributor information identifies 384 bytes of Flash organized as 256 words by 12 bits and four general-purpose I/O lines. The manufacturer describes a compact RISC instruction set with 33 instructions, reducing code-density and learning complexity for basic control products. At the stated 4 MHz operating point, the architecture supports straightforward timing for indicators, simple user interfaces, relay logic, sensing, and low-speed control loops.
The exact operating voltage, memory-map details, oscillator options, reset behavior, I/O electrical limits, and peripheral configuration are not present in the supplied snippets. Those values are therefore marked as data needed rather than inferred. Designers should use the official Microchip documentation for those details before setting operating limits, compiling firmware, or laying out the PCB.
PIC10F204-I/P is appropriate for basic embedded controllers, small sensor interfaces, LED status systems, compact automation controls, and low-power products where a small Flash MCU and through-hole package simplify prototypes or servicing. Through-hole DIP construction also supports educational breadboards and manually assembled control boards. A switching supply, crystal, or larger external circuit is not justified solely from the supplied 4 MHz figure; actual peripheral and clock requirements must be checked in the complete datasheet.
For firmware development, use a programmer and toolchain supported by the selected PIC10F device family. Keep firmware within the verified 384-byte Flash limit and account for bootloader, configuration-word, and application-state requirements. Because only four I/O pins are listed, confirm that the intended interface, programming connector, indicator LEDs, and external controls fit the available pins.
This page consolidates manufacturer architecture details, distributor identification, sourcing links, and design-oriented guidance. It distinguishes verified facts from missing electrical data, helping engineers evaluate PIC10F204-I/P for low-complexity embedded designs without assuming unverified specifications.
Permintaan RFG
Kontak
