SN74LS07N
SN74LS07N - 6-Channel Open-Collector Buffer | Texas Instruments
The Texas Instruments SN74LS07N is a six-channel, non-inverting bipolar buffer and driver with open-collector high-voltage outputs, a 4.75 V to 5.25 V supply range, and a 30 V rated output voltage in a 14-PDIP package. Each channel provides input buffering for TTL-compatible signals and can sink up to 40 mA for relay, lamp, and other high-level interface loads. The open-collector architecture requires an external pull-up resistor and permits wired interfaces, level translation, and multiple drivers to share a bus safely when only one driver pulls low at a time.
An open-collector buffer or driver is a digital interface IC whose output transistor can sink current but cannot actively source current. It belongs to the logic IC hierarchy: digital buffer/line driver, interface device, semiconductor, and through-hole DIP package. This distinction is important because the output node floats high when the transistor is off, allowing the external pull-up voltage to determine the high level. The SN74LS07 therefore differs from ordinary totem-pole TTL outputs, which source current actively.
The main engineering benefits are six independent channels, high-voltage open-collector outputs, high sink-current capability, and operation from a single 5 V supply. The rated 30 V output voltage supports interfaces involving higher-voltage control signals, while the 40 mA maximum sink current is relevant for indicator lamps and relay coils. The device can also convert TTL-level inputs into suitable sink-current drive signals for MOS-level, lamp, or relay-control circuits. Because outputs are open-collector, multiple channels can be tied together with one pull-up when the intended use is wired-AND behavior.
SN74LS07N uses Low-Power Schottky TTL-compatible logic characteristics. Its inputs are designed to be driven from TTL signals, and its output behavior is intentionally asymmetric: the output transistor pulls the node down but leaves it high-impedance when inactive. Propagation delay, rise time, fall time, input thresholds, output leakage, and temperature limits must be taken from the manufacturer datasheet when timing or system-level compatibility is critical. The supplied search results confirm the 4.75 V to 5.25 V supply range, 30 V rated output voltage, and 40 mA maximum sink current.
Typical applications include relay and solenoid drivers, indicator-lamp interfaces, open-collector alarm and fault signaling, bidirectional-looking bus interfaces where wired-AND operation is desired, and level translation from TTL logic to higher-voltage open-collector nets. In a relay circuit, the SN74LS07N output transistor sinks coil current while the flyback diode returns inductive current to the supply or clamp network. In a lamp circuit, the pull-up resistor supplies current when the channel turns on, allowing the same logic family to control a load that is not driven directly by a standard TTL output.
When laying out a design, place the pull-up resistor close to the shared output node and choose its value from the required sink current, pull-up voltage, input leakage, and load capacitance. Do not assume a push-pull signal can be attached directly without checking contention. Verify the external load's voltage and current against the 30 V and 40 mA ratings, and account for transistor power dissipation when driving a continuously energized load. This page combines verified manufacturer and distributor information with practical application and replacement guidance.
RFC
Hubungi kami