SP3232EHET-L/TR
SP3232EHET-L/TR - 3.3V 460kbps RS-232 | MaxLinear
MaxLinear SP3232EHET-L/TR is a 3.3V, 460kbps RS-232 transceiver containing two drivers and two receivers in a 16-SOIC package. The device operates from a 3V to 5.5V supply and supports RS-232 interoperability down to a 2.7V source. Enhanced human-body-model ESD protection of 15kV helps protect the serial interface when cables are connected to portable or hand-held equipment. The target is identified as a full RS-232, 2/2 transceiver and is packaged in the 16-SOIC format identified as 16-SOIC (0.295, 7.50mm width).
An RS-232 transceiver is an interface IC that converts logic-level digital signals into RS-232 line levels and converts incoming RS-232 signals back into logic-compatible receiver outputs. The RS-232 transceiver category sits within serial interface ICs, interface ICs, and integrated circuits. It is commonly used to connect a host controller, embedded processor, test instrument, or industrial terminal to a longer-distance serial port where ground-referenced logic levels cannot drive the cable interface directly.
The SP3232EH family provides two transmit drivers and two receive channels, allowing one port to support bidirectional RS-232 communication. Operation from a 3V to 5.5V supply is useful in portable systems operating from a 3.3V rail, while the 460kbps signaling capability supports higher-speed serial links than legacy low-speed RS-232 implementations. Its enhanced 15kV human-body-model ESD rating is a notable protection feature for connector-facing circuits.
The architecture is optimized for portable and hand-held applications such as notebook and palmtop computers, where low supply voltage, compact packaging, and protection from electrostatic discharge are important. Because the device includes both directions of conversion, it can support two RS-232 lines without requiring separate driver and receiver ICs. The 16-SOIC package also provides a conventional surface-mount footprint compatible with automated assembly, although the exact pin assignment must be taken from the manufacturer pin-description table.
Typical applications include portable data-collection equipment, serial adapters, industrial service interfaces, diagnostic equipment, and embedded control systems that retain an RS-232 port. When one side of a cable is exposed to user contact or poorly controlled external wiring, the 15kV human-body-model ESD rating is especially relevant. Designers should still provide appropriate protection-network coordination and verify that the selected connector, cable, and grounding arrangement meet the system-level interface requirements.
The primary design consideration is power and signal integrity. Place the device close to the RS-232 connector so that board-trace exposure is minimized, connect the transceiver ground to the interface reference ground, and avoid long unprotected traces between the connector and IC. Confirm the 460kbps requirement against the actual cable length and noise environment because data rate, transmission distance, and capacitive loading are strongly related.
This product page consolidates the core electrical ratings, package information, interface use cases, verified drop-in candidates, comparison parameters, and practical layout guidance for faster component selection and PCB planning. Use the MaxLinear SP3232EH product page and manufacturer datasheet for the authoritative electrical characteristics, recommended application circuit, and exact pin configuration.
RFC
Hubungi kami