MCP3561T-E/ST
MCP3561T-E/ST - 24-Bit 153.6kSPS ADC | Microchip Technology
The Microchip Technology MCP3561T-E/ST is a low-noise, 24-bit delta-sigma analog-to-digital converter with two single-ended or one differential input channel and a maximum programmable output data rate of 153.6 kSPS. The device is offered in a 20-pin TSSOP package. Its combination of 24-bit resolution, selectable single-ended or differential measurement, and low-noise delta-sigma architecture makes it suitable for precision instrumentation, industrial process measurement, and sensors producing small differential signals.
An ADC is an interface IC that converts an analog voltage into a digital code for processing by a microcontroller, DSP, or other digital controller. The MCP3561 belongs to the delta-sigma ADC hierarchy, where an internal modulator and digital filter shape the conversion process. Delta-sigma ADCs are especially useful when high resolution, low noise, and relatively narrow-bandwidth measurements matter more than very high conversion rates. This family also supports programmable data rates, allowing designers to balance throughput, filtering, and signal-to-noise performance.
The MCP3561T-E/ST provides 24-bit resolution and operation at up to 153.6 kSPS. Its input architecture accepts two single-ended channels or one differential channel, giving designers flexibility for grounded sensors, resistive bridges, and other front ends. The low-noise characterization makes the converter appropriate for measurements where small input changes must remain distinguishable after digitization. Microchip identifies the MCP3561R as a preferred pin-compatible option for new designs because it adds an onboard voltage reference.
Internally, the MCP3561 uses a delta-sigma conversion architecture and digital filtering to reduce noise. The conversion data rate is programmable, so an application can operate faster when response time is important or more slowly when narrow effective bandwidth and improved noise behavior are preferred. A digital interface transfers conversion results to the host processor. Exact interface timing, filter settings, input impedance, reference requirements, and electrical limits should be confirmed against the manufacturer datasheet before final signal-chain design.
Typical uses include precision pressure and temperature acquisition, low-level process-control instrumentation, laboratory measurement equipment, and industrial sensor interfaces. A differential input is particularly useful when the measured signal includes a common-mode component or when a bridge-style sensor generates a small difference between two nodes. Single-ended operation can simplify systems with a common reference and one sensor output. The converter should be paired with suitable input protection, filtering, reference circuitry, and a grounded analog layout.
When laying out the PCB, keep analog input and reference connections short, place filtering capacitors close to the relevant pins, and maintain a quiet ground path beneath the converter. Avoid routing high-current switching paths beneath the analog section. Confirm the supply voltage, allowable input range, decoupling requirements, and digital interface levels in the manufacturer datasheet, particularly when the source impedance or acquisition interval differs from the application circuit.
This page consolidates the manufacturer product information, verified distributor identification, package details, selection guidance, and design-oriented explanations for engineers evaluating the MCP3561T-E/ST. It also identifies the manufacturer-preferred MCP3561R pin-compatible option for new designs where an onboard voltage reference is useful.
RFQ
İletişim