بەرهەمەکان (1)

P82B715PG4 - 400kHz I2C Bus Extender | Texas Instruments
P82B715PG4

P82B715PG4 - 400kHz I2C Bus Extender | Texas Instruments

The Texas Instruments P82B715PG4 is a 2-bit bidirectional I2C or SMBus buffer and cable extender designed for highly capacitive bus wiring. It operates from 3 V to 12 V, supports bus rates up to 400 kHz, and uses unidirectional analog current amplification to increase the effective sink current available from the connected I2C devices. The device is available in an 8-pin PDIP package for the P82B715PG4 ordering variant and supports bidirectional data transfer through the extended bus. An I2C bus extender is a specialized interface IC placed between two bus segments when passive capacitance, wiring distance, or loading prevents the original controller and slaves from communicating reliably. Its hierarchy is I2C/SMBus buffer or repeater, then bus extender, then interface IC, and finally semiconductor. The extender preserves the two-wire clock-and-data architecture while increasing the usable bus-wiring capacitance from the conventional 400 pF limitation toward a 3 nF limitation described by Texas Instruments. The principal benefit is improved drive capability without changing the host bus protocol. The P82B715PG4 uses analog current amplification to strengthen the sink capability of the connected I2C chips. This makes it useful for separating a heavily loaded bus section, extending wiring to another module, or improving noise and signal-integrity margins when slow or high-capacitance rise times would otherwise make communication unreliable. Its two buffered bits support clock and data paths while retaining bidirectional communication. The device operates across a 3 V to 12 V supply range and supports operation at up to 400 kHz. Texas Instruments describes it as an I2C bus extender for buffering highly capacitive I2C systems. Because the implementation is based on analog current amplification, the designer must observe the manufacturer’s bus rise-time, pull-up, grounding, and capacitance guidelines rather than treating the extender as permission to remove all timing margin. Typical uses include industrial control modules, long sensor harnesses, rack-mounted equipment, test fixtures, and embedded systems where a remote sensor or actuator connects through a cable back to an I2C controller. The P82B715PG4 can be placed at a board boundary or near the remote device to limit the electrical length and capacitance seen by the upstream controller. Layout remains critical. Place the extender close to the more heavily capacitive or remote bus section, provide a continuous ground reference, verify pull-up resistor values on both sides, and observe the datasheet limits for each segment. Confirm operation at the intended 100 kHz or 400 kHz rate under worst-case cable capacitance, temperature, and supply voltage rather than validating only at nominal conditions. This page combines the verified Texas Instruments device description with procurement-oriented pricing fields, replacement guidance, interface design notes, and application-specific selection criteria. It is intended to help engineers determine whether the P82B715PG4 can solve an I2C capacitance or drive problem without unnecessarily redesigning the host controller and bus topology.

RFQ پەیوەندی