LM2904PW vs LM339PWRG4 Comparison

Detailed side-by-side comparison of LM2904PW by Texas Instruments and LM339PWRG4 by Texas Instruments. Compare key specifications, electrical parameters, packaging, lifecycle status, pricing, and availability to determine the best component for your design requirements.

Texas Instruments
LM2904PW LM2904PW - Dual 700 kHz Op Amp, 26 V | Texas Instruments

LM2904PW - Dual 700 kHz Op Amp, 26 V | Texas Instruments

LM2904PW ✓ Active
Texas Instruments
LM339PWRG4 LM339PWRG4 - Quad Differential Comparator | Texas Instruments

LM339PWRG4 - Quad Differential Comparator | Texas Instruments

LM339PWRG4 ✓ Active

Specification Comparison

Parameter LM2904PW LM339PWRG4
Brand Texas Instruments Texas Instruments
Category Amplifier ICs Interface ICs
Lifecycle Status Active Active
Number of Amplifiers 2 circuits —
Product Type Dual general-purpose operational amplifier —
Maximum Supply Voltage 26 V —
Gain-Bandwidth Product 700 kHz —
Typical Supply Current 0.7 mA —
Supply-Current Independence Independent of supply voltage —
Supported Supply Configurations Single supply or split supply —
Common-Mode Input Range Includes ground —
Architecture Voltage feedback, internally frequency compensated —
Package 8-TSSOP, 4.40 mm width 14-TSSOP, 4.40 mm width
Package Length 4.40 mm —
Mounting Type Surface mount Surface mount
Operating Temperature Range [DATA_NEEDED: operating temperature range] 0 °C to [DATA_NEEDED: maximum operating temperature]
Input Offset Voltage [DATA_NEEDED: input offset voltage] —
Input Bias Current [DATA_NEEDED: input bias current] [DATA_NEEDED: typical input-bias current]
Slew Rate [DATA_NEEDED: slew rate] —
RoHS Status [DATA_NEEDED: RoHS status] —
REACH Status [DATA_NEEDED: REACH status] —
AEC-Q100 Qualification [DATA_NEEDED: AEC-Q100 qualification status] —
Comparator Type — General-purpose differential comparator
Number of Channels — 4 channels
Supply Configuration — Single supply or dual supply
Supply Voltage Range — [DATA_NEEDED: operating supply-voltage range]
Maximum-Rated Supply Voltage — 30 V for non-V devices
Tested Supply Voltage — 32 V for non-V devices
Typical Supply-Current Drain — 0.8 mA
Common-Mode Input Voltage Range — Includes ground
Differential Input Voltage Range — Equal to maximum-rated supply voltage
Output Type — Open collector
Logic Compatibility — Compatible with TTL, MOS, and CMOS
Output Saturation Voltage — Low; exact value not stated
Pin Count — 14 pins
Lead-Free Status — [DATA_NEEDED: lead-free status]
RoHS Compliance — [DATA_NEEDED: RoHS compliance status]
REACH Compliance — [DATA_NEEDED: REACH compliance status]

Datasheets & Resources

Browse All Products Create BOM Request Quote