MAX202ESE-TG068 vs MAX202ECSE+TG068 Comparison
Detailed side-by-side comparison of MAX202ESE-TG068 by Analog Devices and MAX202ECSE+TG068 by Analog Devices. Compare key specifications, electrical parameters, packaging, lifecycle status, pricing, and availability to determine the best component for your design requirements.
Specification Comparison
| Parameter | MAX202ESE-TG068 | MAX202ECSE+TG068 |
|---|---|---|
| Brand | Analog Devices | Analog Devices |
| Category | Interface ICs | Interface ICs |
| Lifecycle Status | Active | Active |
| Device Type | RS-232 transceiver | — |
| Channel Configuration | 2 driver / 2 receiver | — |
| Supply Voltage | 5 V | — |
| Data Rate | In excess of 120 kbps | [DATA_NEEDED: maximum data rate] |
| RS-232 Output Signal Levels | Plus or minus 5 V | — |
| Interface Standard | EIA/TIA-232E | — |
| External Charge-Pump Capacitor | 0.1 uF | — |
| Package | 16-pin SOIC | 16-SOIC, 0.154 in x 3.90 mm width |
| Mounting Type | Surface mount | Surface mount |
| Transceiver Type | Full-duplex | — |
| Logic Compatibility | [DATA_NEEDED: logic compatibility] | — |
| Operating Temperature Range | [DATA_NEEDED: operating temperature range] | [DATA_NEEDED: operating temperature range] |
| Supply Current | [DATA_NEEDED: supply current] | [DATA_NEEDED: typical and maximum supply current] |
| Receiver Input Resistance | [DATA_NEEDED: receiver input resistance] | — |
| Driver Output Resistance | [DATA_NEEDED: driver output resistance] | — |
| RoHS Status | RoHS | [DATA_NEEDED: RoHS status] |
| Number of Drivers | — | 2 |
| Number of Receivers | — | 2 |
| Transceiver Configuration | — | 2/2 full RS-232 |
| Supported Protocol | — | RS-232 |
| Supply Voltage Range | — | 4.5 V to 5.5 V |
| ESD Protection | — | 15 kV |
| Packaging | — | Tape and reel |
| Number of Pins | — | 16 |
| Driver Output Count | — | 2 |
| Receiver Input Count | — | 2 |
| Communication Mode | — | Full duplex |
| Operating Voltage | — | 4.5 V to 5.5 V |
| Output High and Low Levels | — | [DATA_NEEDED: RS-232 output voltage levels] |
| Input Hysteresis | — | [DATA_NEEDED: receiver input hysteresis] |
| REACH Status | — | [DATA_NEEDED: REACH status] |