EPC1441PI8N vs EPC1664PI8 Vergleich
Detaillierter Direktvergleich von EPC1441PI8N von Altera und EPC1664PI8 von Altera. Vergleichen Sie die wichtigsten Spezifikationen, elektrischen Parameter, Gehäuse, Lebenszyklusstatus, Preise und Verfügbarkeit, um das beste Bauteil für Ihre Designanforderungen zu ermitteln.
Altera
EPC1441PI8N - 440Kb OTP Config PROM, 8-PDIP | Altera / Intel
EPC1441PI8N ⚠ Letzte BestellmöglichkeitSpezifikationsvergleich
| Parameter | EPC1441PI8N | EPC1664PI8 |
|---|---|---|
| Marke | Altera | Altera |
| Kategorie | Memory ICs | FPGA & CPLD |
| Lebenszyklusstatus | Letzte Kaufgelegenheit | Obsolete |
| Lagerstatus | In Stock | In Stock |
| Stückpreis (USD) | $3,55 | $8,75 |
| Speichertyp | OTP Configuration PROM (poly-fuse) | — |
| Memory Capacity | 440,800 bits (440 Kbit) | — |
| Configuration Interface | Altera Serial (PS) configuration | Serial (DATA, DCLK, nCONFIG, CONF_DONE) |
| Supply Voltage VCC | 5.0 V nominal (4.75 V to 5.25 V) | — |
| Active Supply Current ICC | [DATA_NEEDED: typical active ICC] | — |
| Standby Supply Current ICCSTBY | approximately 50 uA | — |
| Programming Method | Off-board PROM programmer (poly-fuse OTP) | — |
| Configuration Time | <100 ms typical for FLEX10KA loading | — |
| Betriebstemperatur | -40C to +85C (industrial) | [DATA_NEEDED: industrial/commercial range] |
| Gehäuse | 8-pin PDIP (Plastic DIP, through-hole) | PDIP-8 (PI8) |
| Pin-Anzahl | 8 | — |
| Montageart | Through-hole (THT) | Through-Hole |
| Lead-Free / RoHS | Non-RoHS (legacy through-hole); check suffix for Pb-free option | — |
| Compatible FPGA Families | FLEX10K, FLEX10KA, FLEX6000, APEX20K series | — |
| Family Position | Top-of-family (largest density: 440Kb) | — |
| Programming Voltage | [DATA_NEEDED: VPP programming voltage] | — |
| Endurance | One-time programmable (no reprogram cycles) | — |
| Memory Density | — | 16 Mb (16,777,216 bits) |
| Device Family | — | Enhanced Configuration Device (EPC) |
| Supported FPGA Families | — | Stratix, Cyclone, APEX II, APEX 20K, Mercury, ACEX 1K |
| Programming Interface | — | JTAG / ByteBlaster / MasterBlaster |
| Cascade Support | — | Yes - two EPC devices can be chained |
| In-System Programmable | — | Yes (ISP via JTAG) |
| Versorgungsspannung | — | [DATA_NEEDED: VCC range from datasheet] |
| RoHS-Status | — | [DATA_NEEDED: from datasheet] |
| Lead-Free | — | [DATA_NEEDED: from datasheet] |
| MSL-Level | — | [DATA_NEEDED: from datasheet] |
| Read-Back Support | — | Yes (verify/blank-check) |