ADM485AR vs ADM485ARZ Comparación
Comparación detallada lado a lado de ADM485AR por Analog Devices y ADM485ARZ por Analog Devices. Compare las especificaciones clave, los parámetros eléctricos, el encapsulado, el estado del ciclo de vida, los precios y la disponibilidad para determinar el mejor componente para los requisitos de su diseño.
Analog Devices
ADM485ARZ - 5V 5Mbps Half-Duplex RS-485/RS-422 Transceiver | Analog Devices (Tape & Reel)
ADM485ARZ ✓ ActivoComparación de especificaciones
| Parámetro | ADM485AR | ADM485ARZ |
|---|---|---|
| Marca | Analog Devices | Analog Devices |
| Categoría | Interface ICs | Interface ICs |
| Estado del ciclo de vida | Activo | Activo |
| Estado del stock | In Stock | In Stock |
| Precio unitario (USD) | $0,00 | $1,62 |
| Product Type | Differential line transceiver | — |
| Supported Standards | EIA RS-485 and RS-422 | — |
| Tensión de alimentación | 5 V | 5 V (single supply) |
| Driver Count | 1 | — |
| Receiver Count | 1 | — |
| Communication Mode | High-speed bidirectional | — |
| Bus Architecture | Multipoint balanced transmission line | — |
| Driver and Receiver Enable | Driver and receiver can be enabled | — |
| Signal Type | Differential balanced signaling | — |
| Logic Interface | [DATA_NEEDED: logic input and output voltage levels] | — |
| Maximum Data Rate | [DATA_NEEDED: maximum data rate] | — |
| Differential Driver Output | [DATA_NEEDED: differential output voltage and current] | — |
| Receiver Sensitivity | [DATA_NEEDED: receiver sensitivity] | — |
| Common-Mode Voltage Range | [DATA_NEEDED: common-mode voltage range] | — |
| Propagation Delay | [DATA_NEEDED: propagation delay] | — |
| Rango de temperatura de funcionamiento | [DATA_NEEDED: operating temperature range] | -40 C to +85 C |
| Encapsulado | 8-pin SOIC | SOIC-8 (SO-8) / SO-8 |
| Tipo de montaje | [DATA_NEEDED: surface-mount or through-hole mounting] | Surface Mount |
| ESD Protection | [DATA_NEEDED: ESD protection rating] | [DATA_NEEDED: ESD HBM rating] |
| RoHS | unknown | — |
| REACH | unknown | — |
| AEC-Q100 | unknown | — |
| Type | — | Transceiver |
| Protocol | — | RS-422, RS-485 |
| Number of Drivers/Receivers | — | 1/1 |
| Duplex | — | Half |
| Velocidad de datos | — | 5 Mbps (max) |
| Receiver Hysteresis | — | [DATA_NEEDED: receiver hysteresis] |
| Common-Mode Range | — | -7 V to +12 V |
| Driver Differential Output | — | [DATA_NEEDED: VOD min/max] |
| Estado RoHS | — | Compliant |
| REACH Status | — | Unaffected |
| Nivel MSL | — | 1 (Unlimited) |
| Compliance | — | ROHS3 Compliant |
| Enable Pins | — | Yes (DE driver enable, RE receiver enable, active-low/GPIO logic) |