MAX3483AEASA+ vs ISL3172EIUZ-T Comparación
Comparación detallada lado a lado de MAX3483AEASA+ por Analog Devices y ISL3172EIUZ-T por Renesas Electronics. Compare las especificaciones clave, los parámetros eléctricos, el encapsulado, el estado del ciclo de vida, los precios y la disponibilidad para determinar el mejor componente para los requisitos de su diseño.
Renesas Electronics
ISL3172EIUZ-T - ±15kV ESD, 3.3V RS-485/422 Transceiver | Renesas
ISL3172EIUZ-T ✓ ActivoComparación de especificaciones
| Parámetro | MAX3483AEASA+ | ISL3172EIUZ-T |
|---|---|---|
| Marca | Analog Devices | Renesas Electronics |
| Categoría | Interface ICs | Interface ICs |
| Estado del ciclo de vida | Activo | Activo |
| Tensión de alimentación | 3.3 V | — |
| Maximum Data Rate | 20 Mbps | — |
| ESD Protection | ±20 kV | — |
| Transceiver Configuration | 1/1 half-duplex transceiver | — |
| Supported Standards | RS-422 and RS-485 | — |
| Driver Architecture | Slew-rate-limited differential driver | — |
| Receiver Architecture | Differential receiver | — |
| Encapsulado | 8-pin SOIC | 8-MSOP (UZ) |
| Tipo de montaje | Surface mount | Surface Mount |
| Number of Drivers | 1 | — |
| Number of Receivers | 1 | — |
| Direction Control | [DATA_NEEDED: transceiver direction-control method] | — |
| Rango de temperatura de funcionamiento | [DATA_NEEDED: operating temperature range] | — |
| Corriente de alimentación | [DATA_NEEDED: supply current] | — |
| Propagation Delay | [DATA_NEEDED: driver and receiver propagation delay] | — |
| Common-Mode Voltage Range | [DATA_NEEDED: receiver common-mode voltage range] | — |
| Maximum Bus Load | [DATA_NEEDED: maximum unit loads per bus] | — |
| Estado RoHS | [DATA_NEEDED: RoHS status] | Compliant |
| REACH Status | [DATA_NEEDED: REACH status] | — |
| Función | — | Transceiver |
| Number of Drivers/Receivers | — | 1/1 |
| Protocol | — | RS-422, RS-485 |
| Duplex | — | Half |
| Data Rate (max) | — | 250 kbps |
| Supply Voltage (VCC) | — | 3.0 V to 3.6 V |
| Temperatura de funcionamiento | — | -40 °C to +85 °C |
| Bus Pin ESD Protection (HBM) | — | ±15 kV |
| Bus Pin ESD Protection (IEC 61000-4-2 Air) | — | ±15 kV |
| Bus Pin ESD Protection (IEC 61000-4-2 Contact) | — | [DATA_NEEDED: contact-discharge rating] |
| Unit Load | — | 1/8 (up to 256 nodes per bus) |
| Receiver Common-Mode Range | — | -7 V to +12 V |
| Fail-Safe Receiver | — | Full (logic-high on open/short/idle) |
| Bus Current (driver loaded) | — | +125 µA / -100 µA |
| Quiescent Supply Current | — | 510 µA (typical, no load) |
| Driver Enable | — | Yes (active-high, DE pin) |
| Receiver Enable | — | Yes (active-low, RE pin) |
| Lead-Free / Halogen-Free | — | Yes (per Renesas product page) |
| Nivel MSL | — | [DATA_NEEDED: MSL rating] |