315 - SR716SW Silver Oxide 1.55V Watch Battery | Energizer
N.º de pieza: 315 ✓ Activo| Cant. | Precio unitario | Total |
|---|---|---|
| 1 | $2.95 | $2,95 |
| 10 | $24.5 | $245,00 |
| 100 | $220 | $22.000,00 |
| 500 | $1025 | $512.500,00 |
| 1.000 | $1950 | $1.950.000,00 |
315 Descripción general
Silver-oxide watch batteries (chemistry code SR) are primary non-rechargeable cells that use a zinc anode and silver-oxide cathode, with alkaline electrolyte. Compared with alkaline button cells (LR) or mercury cells (former H prefix), silver-oxide chemistry provides a flatter voltage plateau throughout the discharge cycle, which keeps the watch movement's step-motor drive amplitude constant and prevents the "end-of-life slowdown" that alkaline cells exhibit. The SR716SW family occupies the niche between the smaller SR621SW (6.8 mm) and the larger SR916SW (9.5 mm).
Key features include 1.55 V nominal voltage, 7.9 mm × 1.65 mm dimensions (per IEC 60086), leak-resistant sealed construction, and an operating temperature window of 0 °C to +60 °C. Capacity is approximately 22 mAh (per Energizer watch-cell datasheets), with a typical continuous drain of 30 µA at 1.5 V end-point for analog quartz movements. Shelf life is rated up to 5 years at +20 °C storage.
Common alias part numbers include SR716SW, SR67, SR716, V315, D315, B315L, 530, 280-56, SB-AT, 614, HA, and the IEC code SR67. All share identical dimensions and voltage; only capacity may vary slightly between brands due to cathode formulation differences.
Typical applications include analog quartz wristwatches, small digital timepieces, calculator backup cells, glucometer RTC backup, and low-power CMOS logic RTC retention. The thin 1.65 mm profile makes it the standard cell for slim dress watches with case thickness under 5 mm.
Avoid mixing silver-oxide and alkaline watch cells in the same device - their voltage profiles differ and may cause erratic stepping. Store unused cells in original blister packaging to preserve shelf life and prevent inadvertent short-circuit on metal surfaces.
This page consolidates the manufacturer-published cell dimensions, the cross-reference equivalency map, and known drop-in equivalents across brands not found in a single manufacturer datasheet.
Alternativas directas para 315 — mismo encapsulado, compatible pin a pin. Se excluyen las piezas de otro encapsulado que requieren retrabajo de la PCB.
Herramienta de comparación rápida — seleccione piezas alternativas para compararlas lado a lado:
315
✅ Sustitución directa✓ En stock
$2.95 / unidad
Ver hoja de datos →SR716SW
✅ Sustitución directa📋 Alternativa de referencia (no en el catálogo)
V315
✅ Sustitución directa📋 Alternativa de referencia (no en el catálogo)
D315
✅ Sustitución directa📋 Alternativa de referencia (no en el catálogo)
SR716SW
✅ Sustitución directa📋 Alternativa de referencia (no en el catálogo)
SR716SW
✅ Sustitución directa📋 Alternativa de referencia (no en el catálogo)
315 Especificaciones
| Chemistry | Silver Oxide (Zn/Ag2O) |
| Nominal Voltage | 1.55 V |
| IEC Designation | SR67 (industry alias SR716SW) |
| Diameter | 7.9 mm |
| Height | 1.65 mm |
| Capacity (typical) | 22 mAh |
| Continuous Drain (typical) | 30 µA |
| Temperatura de funcionamiento | 0 °C to +60 °C |
| Storage Temperature | -20 °C to +45 °C |
| Shelf Life | 5 years (at +20 °C) |
| Form Factor | Button cell (coin) |
| Rechargeable | No (primary cell) |
| Equivalent Codes | SR716SW, SR67, SR716, V315, D315, 530, 280-56, SB-AT, 614, HA |
| Tipo de montaje | Press-fit (cell holder) |
| Estado RoHS | Compliant |
Guía de configuración de pines de 315 standard
Configuración de pines para 315 (encapsulado standard). La numeración de pines, las funciones y los diagramas de conexión se definen en la hoja de datos del fabricante. Consúltela para conocer el footprint exacto y las directrices de soldadura.
No hay datos detallados de patillaje disponibles para 315.
Consulte la hoja de datos para ver la configuración completa de patillas.
Aplicaciones típicas
315 es adecuado para 6 aplicacións: Analog Quartz Wristwatch, Digital Watch Backup Cell, Calculator and Organizer RTC Backup, Glucometer and Medical Device Backup, CMOS Logic RTC Retention, Hearing Aid and Assistive Device Power.
Analog Quartz Wristwatch
The Energizer 315 (SR716SW) is the de facto standard power source for thin analog quartz wristwatches. With 1.55 V nominal and 22 mAh typical capacity, it sustains the 32 kHz quartz crystal oscillator and bipolar step-motor drive for 2-3 years per cell. The 7.9 × 1.65 mm dimensions fit dress watches with case thickness under 5 mm where larger 9.5 mm cells like SR916SW will not seat. Silver-oxide chemistry's flat voltage plateau (versus sloping alkaline discharge) keeps motor drive amplitude constant, preventing the late-life slowing visible with cheaper LR cells. Pair with a Renata 315 or Maxell SR716SW equivalent for OEM service replacements.
Recomendado
Digital Watch Backup Cell
The 315 cell also powers low-power digital LCD watches with simple time/date display. Continuous drain is typically 5-10 µA, so the 22 mAh capacity delivers 2-4 years of service. The flat discharge curve maintains LCD contrast throughout cell life, where alkaline cells would dim gradually. Not suitable for high-drain digital watches with backlight, alarm, or chronograph - those need SR716W high-drain variant. Verify the watch movement's specified chemistry; some Seiko and Casio modules require SR-only cells to maintain calibration.
Recomendado
Calculator and Organizer RTC Backup
Vintage calculators, PDAs, and electronic organizers used the 315 (SR716SW) as a backup cell for retaining RAM and clock settings when main batteries were removed for replacement. The 1.55 V cell provides continuous 5-15 µA trickle drain to RTC and CMOS SRAM, preserving memory for 3-5 years. Modern equivalents include the BR-1225 lithium backup, but legacy Sharp, Casio, and HP organizers from the 1990s-2000s specified the 315. Substitute only with same-chemistry silver-oxide to avoid alkaline leakage damage to the PCB.
Recomendado
Glucometer and Medical Device Backup
Some portable medical devices (glucometers, blood pressure monitors, pill dispensers) use the 315 cell as RTC backup to retain time/date stamps and last-reading memory when primary AA/AAA batteries are swapped. The 1.55 V silver-oxide chemistry is preferred over alkaline because flat discharge prevents clock drift that could mis-stamp medical readings. Capacity of 22 mAh is sufficient for 2-3 year backup duty. Cross-reference equivalents (SR716SW, V315, D315) from medical-grade suppliers like Renata meet device reliability requirements.
Recomendado
CMOS Logic RTC Retention
The 315 cell is occasionally used as a backup supply for low-power CMOS logic RTC chips in industrial controllers and instrumentation. The 1.55 V output is sufficient to maintain oscillator and RAM when main 3.3 V or 5 V rail is removed for service. Capacity of 22 mAh provides months of backup for typical 1-3 µA RTC drain. For new designs, prefer lithium cells like BR-1225 or BR-1632 for wider temperature range; the 315 is reserved for legacy systems with established mechanical holders.
Recomendado
Hearing Aid and Assistive Device Power
Older analog and early digital hearing aids used the 315 (SR716SW) as primary power before zinc-air 675/13 became standard. Some slim in-ear models retain the 315 for its compact 1.65 mm profile. Capacity of 22 mAh supports 5-7 days of 16-hour daily use at 1-2 mA average drain. Modern hearing aids use zinc-air chemistry for higher energy density, but legacy devices and tinnitus-masker units still specify the 315. Substitute only with same silver-oxide chemistry; alkaline equivalents reduce service life by ~40%.
Recomendado
Resumen de productos recomendados
Datos de referencia de ingeniería para 315 — comparación, orientación de diseño e información de cumplimiento.
Guía de selección
Comparación con alternativas
| Parámetro | Este producto | 315 | SR716SW | V315 | D315 | SR716SW |
|---|---|---|---|---|---|---|
| Brand | Energizer | Renata | Maxell | Varta | Duracell | Sony |
| Package | Button cell 7.9x1.65 mm | Button cell 7.9x1.65 mm - same | Button cell 7.9x1.65 mm - same | Button cell 7.9x1.65 mm - same | Button cell 7.9x1.65 mm - same | Button cell 7.9x1.65 mm - same |
| Nominal Voltage | 1.55 V | 1.55 V | 1.55 V | 1.55 V | 1.55 V | 1.55 V |
| Chemistry | Silver Oxide | Silver Oxide | Silver Oxide | Silver Oxide | Silver Oxide | Silver Oxide |
| Diameter | 7.9 mm | 7.9 mm | 7.9 mm | 7.9 mm | 7.9 mm | 7.9 mm |
| Height | 1.65 mm | 1.65 mm | 1.65 mm | 1.65 mm | 1.65 mm | 1.65 mm |
| Capacity (typical) | 22 mAh | 23 mAh | 22 mAh | 21 mAh | 22 mAh | 20 mAh |
| IEC Code | SR67 / SR716SW | SR67 / SR716SW | SR67 / SR716SW | SR67 / SR716SW | SR67 / SR716SW | SR67 / SR716SW |
Diferenciadores clave
- Wide cross-reference availability across multiple brands (frente a SR716SW (Maxell))
- Watchmaker-preferred equivalent exists (frente a Renata 315)
- Higher capacity versus legacy alkaline equivalents (frente a LR716 (alkaline))
Notas de diseño
Do not substitute silver-oxide 315 with alkaline LR716 - although dimensions match (7.9 × 1.65 mm), the alkaline cell's sloping discharge curve causes watch movements to gradually slow as the cell depletes. Silver-oxide maintains a flat ~1.55 V plateau to end-of-life, keeping timekeeping accuracy consistent. Watchmakers report 30-40% service life reduction with alkaline substitutions.
Always install the 315 cell with the + terminal facing up into the cell holder. The flat top side (marked with cell code '315') is positive; the bottom with the case crimp seam is negative. Reverse polarity can permanently damage the quartz movement's CMOS IC. Verify polarity markings on the cell holder clip before insertion.
Estimated: a 22 mAh 315 cell powering a 2 µA continuous drain analog quartz movement provides approximately 11,000 hours or 3 years of service life (22 mAh / 0.002 mA = 11,000 h). Actual life varies with temperature, pulse current from step-motor actuation, and self-discharge (~1-2% per year). Always specify a fresh cell with at least 4 years of remaining shelf life for service.
Información de cumplimiento
RoHS compliant per Energizer product specifications. Not applicable for AEC-Q100 (consumer button cell). Contains no lead or mercury per IEC 60086 silver-oxide standards.
