HI7191IPZ
HI7191IPZ - 24-Bit Sigma-Delta ADC, ±5V, 20-PDIP | Renesas
The Renesas (formerly Intersil) HI7191IPZ is a 24-bit, high-precision instrumentation sigma-delta analog-to-digital converter that operates from ±5V analog and digital supplies and is housed in a 20-pin PDIP (plastic DIP) through-hole package. The device integrates a fully differential signal input path, a fully differential reference input, and an on-chip programmable-gain instrumentation amplifier (PGIA) with binary gain steps from 1 to 128, eliminating the need for an external pre-amplifier in most transducer front-ends. The serial I/O port is compatible with both Motorola 6805/11-series SPI and Intel 8051-series SSR synchronous transfer formats.
An ADC of the sigma-delta type is a noise-shaping converter that oversamples the input at a rate far above the Nyquist frequency and pushes quantization noise out of the baseband, trading speed for resolution. The HI7191IPZ is part of the instrumentation ADC category, which sits hierarchically inside precision data converters, alongside successive-approximation (SAR) ADCs at lower resolution and wider bandwidth. Compared with successive-approximation ADCs, instrumentation sigma-delta converters such as the HI7191IPZ deliver far higher effective resolution at low word rates while integrating input conditioning, making them ideal for direct connection to bridge sensors, thermocouples, and other low-level differential sources.
Key differentiating features include 24-bit resolution, the on-chip PGIA with gains of 1, 2, 4, 8, 16, 32, 64, and 128, on-chip calibration registers that allow user-initiated self- and system-calibration routines, and a low-power standby mode controlled through the serial interface. The combination of differential inputs, a differential reference, and integrated gain front-end allows the converter to maintain high common-mode rejection and resolution over the full-scale input range.
The converter architecture combines a charge-balancing modulator, a digital decimation filter, and the integrated PGIA, yielding a single-chip instrumentation front-end. The HI7191IPZ targets a maximum output word rate of approximately 2 kSPS at full 24-bit resolution, making it suited to DC and quasi-DC precision measurements rather than wideband signal acquisition. The HI7191IPZ is pin-compatible with the HI7190IPZ, which shares the same die but offers tighter linearity specifications for the most demanding calibration channels.
Typical applications include precision weighing scales and load-cell readouts, industrial process-control pressure and strain instrumentation, laboratory and analytical instrumentation such as pH and conductivity meters, thermocouple and RTD temperature acquisition modules, and battery-powered portable instrumentation where the standby mode and low input current draw help extend operating life. Designers most often place the HI7191IPZ between the transducer bridge and an external microcontroller, with the MCU configuring PGIA gain, calibration, and channel selection via the four-wire synchronous serial interface.
Key design considerations include providing well-decoupled analog and digital ±5V supplies, buffering inputs where source impedance is high, and writing a calibration routine that exercises the on-chip zero-scale and full-scale registers. Note that the HI7191IPZ is currently listed as obsolete on the Renesas product page, so designers should confirm long-term availability or plan around the pin-compatible HI7190IPZ.
This page synthesizes distributor pricing, package information, parametric comparison data, and pin-compatible alternatives not aggregated on any single distributor page.
RFQ
تماس