ATSAMD21E16LMOTOR vs ATSAMD20-XPRO Comparaison
Comparaison détaillée côte à côte de ATSAMD21E16LMOTOR par Microchip Technology et ATSAMD20-XPRO par Microchip Technology. Comparez les spécifications clés, les paramètres électriques, le conditionnement, le statut de cycle de vie, les prix et la disponibilité pour déterminer le meilleur composant pour vos exigences de conception.
Microchip Technology
ATSAMD21E16LMOTOR - SAM D21 BLDC Motor Control Kit | Microchip
ATSAMD21E16LMOTOR ✓ ActifMicrochip Technology
ATSAMD20-XPRO - SAM D20 Xplained Pro Cortex-M0+ Eval Kit | Microchip
ATSAMD20-XPRO ✓ ActifComparaison des spécifications
| Paramètre | ATSAMD21E16LMOTOR | ATSAMD20-XPRO |
|---|---|---|
| Marque | Microchip Technology | Microchip Technology |
| Catégorie | Development Boards | Development Boards |
| Statut du cycle de vie | Actif | Actif |
| Statut du stock | In Stock | In Stock |
| Prix unitaire (USD) | $53,40 | $70,00 |
| Product Type | Motor Control Development Board / MCU Card | — |
| Base MCU | ATSAMD21E16L | — |
| Core Architecture | ARM Cortex-M0+ 32-bit | — |
| Maximum CPU Clock | 48 MHz | — |
| Flash Memory | 64 KB | 256 KiB |
| SRAM | 8 KB | 32 KiB |
| USB Interface | Full-Speed USB Device | — |
| GPIO Count | Up to 26 | — |
| Expansion Interface | mikroBUS socket (MikroElektronika click boards) | — |
| Preloaded Firmware | Hall-sensor based block commutation for 3-phase BLDC | — |
| Companion Baseboard | ATSAMD21BLDC24V-STK | — |
| Target Motor Type | Low-voltage 3-phase brushless DC (24 V) | — |
| On-board Debugger | [DATA_NEEDED: on-board debugger presence] | — |
| Operating Voltage | 3.3 V (MCU card); 24 V motor bus on baseboard | — |
| Series | SAM D21, Functional Safety (FuSa) | SAM D20 Xplained Pro |
| Statut RoHS | Compliant | Compliant |
| Manufacturer | — | Microchip Technology |
| Target MCU | — | ATSAMD20J18A |
| Core | — | ARM Cortex-M0+ 32-bit |
| Clock Speed | — | 48 MHz |
| Crystal Oscillator | — | 32.768 kHz |
| Debug Interface | — | Embedded Atmel EDBG (USB HID) |
| Extension Headers | — | 3 x Xplained Pro 20-pin |
| Arduino Shield Compatibility | — | Yes, R3 footprint |
| Power Input | — | USB micro-B 5 V |
| Board Form Factor | — | Xplained Pro (approx. 75 x 100 mm) |
| Toolchain Support | — | Microchip Studio / Atmel Studio / MPLAB X IDE / ASF |
| Lead-Free | — | Yes |
| Température de fonctionnement | — | 0C to +60C (commercial eval kit) |