EPC16QC-100T vs EPC8QC100 Comparaison
Comparaison détaillée côte à côte de EPC16QC-100T par Altera et EPC8QC100 par Altera. Comparez les spécifications clés, les paramètres électriques, le conditionnement, le statut de cycle de vie, les prix et la disponibilité pour déterminer le meilleur composant pour vos exigences de conception.
Comparaison des spécifications
| Paramètre | EPC16QC-100T | EPC8QC100 |
|---|---|---|
| Marque | Altera | Altera |
| Catégorie | Memory ICs | Memory ICs |
| Statut du cycle de vie | Obsolete | Obsolete |
| Statut du stock | In Stock | In Stock |
| Prix unitaire (USD) | $14,50 | $17,50 |
| Type de mémoire | Flash Configuration PROM (in-system programmable) | Configuration PROM (Flash-based) |
| Memory Density | 16 Mbit (2 Mbyte) | — |
| Supported FPGA Families | Stratix, APEX II, APEX 20K, Mercury, ACEX 1K, FLEX 10K | — |
| Configuration Data Width | 8-bit or 16-bit (cascaded dual-device mode) | — |
| Configuration Modes | Serial (single device), Parallel (two cascaded devices) | — |
| Data Compression Support | Yes (35% to 55% bitstream reduction typical) | — |
| JTAG / Boundary Scan | IEEE 1149.1 compliant, in-system programmable | — |
| Tension d'alimentation | 3.3 V | 3.3 V |
| Boîtier | 100-pin PQFP (20 x 14 mm), 0.65 mm pitch | 100-Pin PQFP (20 x 14 mm) |
| Température de fonctionnement | [DATA_NEEDED: Operating temperature range] | 0C to +70C (Commercial) |
| Cascade Interface | nCE / nOE handshake for multi-device chains | — |
| Programming Interface | JTAG (IEEE 1149.1) and serial | — |
| Endurance | [DATA_NEEDED: Program/erase cycle rating] | — |
| Data Retention | [DATA_NEEDED: Data retention specification] | — |
| Statut RoHS | unknown | [DATA_NEEDED: RoHS compliance] |
| Lead-Free | unknown | — |
| Niveau MSL | [DATA_NEEDED: Moisture sensitivity level] | — |
| Type de montage | Surface Mount | Surface Mount |
| Taille de mémoire | — | 8 Mbit |
| Flash Access Time | — | 90 ns (~10 MHz) |
| Configuration Bus Width | — | 16-bit (DQ[]) |
| Configuration Bandwidth | — | Up to 160 Mbps |
| Decompression Support | — | Yes (Altera proprietary) |
| Supported Configuration Modes | — | FPP, PS, AS (FPGA-dependent) |
| ISP Interface | — | JTAG (IEEE 1149.1) |
| Compatible FPGA Families | — | Stratix, APEX II, APEX 20K, Mercury, ACEX 1K, FLEX 10K |
| Lead Free | — | [DATA_NEEDED: lead-free status] |