EPC2TC32UCF48 vs EPC2TC32UCAF48 Comparaison
Comparaison détaillée côte à côte de EPC2TC32UCF48 par Intel et EPC2TC32UCAF48 par Altera. Comparez les spécifications clés, les paramètres électriques, le conditionnement, le statut de cycle de vie, les prix et la disponibilité pour déterminer le meilleur composant pour vos exigences de conception.
Comparaison des spécifications
| Paramètre | EPC2TC32UCF48 | EPC2TC32UCAF48 |
|---|---|---|
| Marque | Intel | Altera |
| Catégorie | Memory ICs | FPGA & CPLD |
| Statut du cycle de vie | NRND | Obsolete |
| Statut du stock | In Stock | In Stock |
| Prix unitaire (USD) | $10,85 | $14,20 |
| Type de mémoire | Non-volatile configuration PROM (CMOS Flash-based) | — |
| Memory Density | 1.6 Mbit (1.6 Mb / 32 Mbit raw) | — |
| Memory Configuration | Serial configuration bitstream storage | — |
| Supply Voltage (VCC) | 3.0 V to 3.6 V (3.3 V typical) | 3.3 V nominal |
| Supply Voltage (VCCIO) | 1.8 V / 2.5 V / 3.3 V (bank-level) | — |
| Output Drive Current (VCCIO) | [DATA_NEEDED: IOH/IOL at 3.3 V VCCIO] | — |
| Programming Interface | IEEE Std. 1149.1 JTAG (in-system programmable) | — |
| Configuration Interface | Altera serial PROM interface (DCLK, DATA, nCONFIG, nSTATUS, CONF_DONE) | — |
| Supported Configuration Modes | FPP, AS, PS, JTAG (mode dependent on target FPGA MSEL pins) | — |
| Daisy Chain Support | Yes (multi-device cascade for >16 Mbit FPGAs) | — |
| Maximum Cascaded Capacity | Up to 16 Mbit total across chain | — |
| Température de fonctionnement | 0C to +70C (commercial) | [DATA_NEEDED: commercial 0-70C vs industrial -40-85C variant] |
| Boîtier | 48-pin TQFP (7x7 mm) | 32-pin TQFP (CAF48 designation per Altera ordering code) |
| Type de montage | Surface Mount | Surface Mount |
| Niveau MSL | [DATA_NEEDED: MSL rating] | [DATA_NEEDED: MSL classification] |
| Statut RoHS | [DATA_NEEDED: confirm RoHS compliance] | [DATA_NEEDED: per ordering code; older CAF48 lots were non-RoHS] |
| Lead Free | [DATA_NEEDED: confirm lead-free] | — |
| Taille de mémoire | — | 1.6 Mb |
| Device Family | — | EPC2 (Enhanced Configuration Device) |
| Programmability | — | In-system programmable (ISP) via JTAG |
| Interface | — | 4-wire serial (nCS, DCLK, DATA, nINIT_CONF) + JTAG |
| FPGA Compatibility | — | Altera SRAM-based LUT FPGAs (Cyclone, Stratix, APEX, ACEX, FLEX, MAX 9000) |
| Cascading | — | Supported for bitstreams larger than 1.6 Mb |
| Data Retention | — | 10 years typical (EEPROM-based) |
| Programming Cycles | — | 100 cycles minimum (EEPROM endurance) |
| Process Technology | — | CMOS EEPROM |