EPC8QI100N vs EPC8QC100 Comparaison
Comparaison détaillée côte à côte de EPC8QI100N par Altera et EPC8QC100 par Altera. Comparez les spécifications clés, les paramètres électriques, le conditionnement, le statut de cycle de vie, les prix et la disponibilité pour déterminer le meilleur composant pour vos exigences de conception.
Comparaison des spécifications
| Paramètre | EPC8QI100N | EPC8QC100 |
|---|---|---|
| Marque | Altera | Altera |
| Catégorie | EEPROM | Memory ICs |
| Statut du cycle de vie | NRND | Obsolete |
| Statut du stock | In Stock | In Stock |
| Prix unitaire (USD) | $16,90 | $17,50 |
| Manufacturer | Altera (Intel) | — |
| Part Family | EPC8 (Enhanced Configuration) | — |
| Device Type | Configuration PROM for SRAM-based FPGAs | — |
| Taille de mémoire | 8 Mbit (8,388,608 bits) | 8 Mbit |
| Programmable Type | In System Programmable (Flash) | — |
| Configuration Interface | Altera serial (4-wire: DATA, DCLK, nCS, nINIT_CONF) | — |
| Maximum Configuration Clock | 50 MHz | — |
| On-Chip Decompression | Yes (Altera compression algorithm) | — |
| Supply Voltage (VCC) | 3.0 V to 3.6 V | — |
| Température de fonctionnement | -40 °C to +85 °C (Industrial) | 0C to +70C (Commercial) |
| Boîtier | 100-PQFP / 100-BQFP (20 x 14 mm) | 100-Pin PQFP (20 x 14 mm) |
| Nombre de broches | 100 | — |
| Type de montage | Surface Mount | Surface Mount |
| Lead-Free / RoHS | Yes (per distributor listings) | — |
| JTAG (IEEE 1149.1) ISP | Supported | — |
| Multi-Device Daisy-Chain | Supported | — |
| Target FPGA Families | ACEX 1K, APEX 20K, APEX II, Arria GX, Cyclone, Cyclone II, FLEX 10K, FLEX 6000, Mercury, Stratix, Stratix GX, Stratix II, Stratix II GX | — |
| Packaging | Tray | — |
| Type de mémoire | — | Configuration PROM (Flash-based) |
| Flash Access Time | — | 90 ns (~10 MHz) |
| Configuration Bus Width | — | 16-bit (DQ[]) |
| Configuration Bandwidth | — | Up to 160 Mbps |
| Decompression Support | — | Yes (Altera proprietary) |
| Supported Configuration Modes | — | FPP, PS, AS (FPGA-dependent) |
| ISP Interface | — | JTAG (IEEE 1149.1) |
| Tension d'alimentation | — | 3.3 V |
| Compatible FPGA Families | — | Stratix, APEX II, APEX 20K, Mercury, ACEX 1K, FLEX 10K |
| Statut RoHS | — | [DATA_NEEDED: RoHS compliance] |
| Lead Free | — | [DATA_NEEDED: lead-free status] |