ISL3172EIUZ-T vs MAX3483AEASA+ Comparaison
Comparaison détaillée côte à côte de ISL3172EIUZ-T par Renesas Electronics et MAX3483AEASA+ par Analog Devices. Comparez les spécifications clés, les paramètres électriques, le conditionnement, le statut de cycle de vie, les prix et la disponibilité pour déterminer le meilleur composant pour vos exigences de conception.
Renesas Electronics
ISL3172EIUZ-T - ±15kV ESD, 3.3V RS-485/422 Transceiver | Renesas
ISL3172EIUZ-T ✓ ActifComparaison des spécifications
| Paramètre | ISL3172EIUZ-T | MAX3483AEASA+ |
|---|---|---|
| Marque | Renesas Electronics | Analog Devices |
| Catégorie | Interface ICs | Interface ICs |
| Statut du cycle de vie | Actif | Actif |
| Fonction | Transceiver | — |
| Number of Drivers/Receivers | 1/1 | — |
| Protocol | RS-422, RS-485 | — |
| Duplex | Half | — |
| Data Rate (max) | 250 kbps | — |
| Supply Voltage (VCC) | 3.0 V to 3.6 V | — |
| Température de fonctionnement | -40 °C to +85 °C | — |
| Bus Pin ESD Protection (HBM) | ±15 kV | — |
| Bus Pin ESD Protection (IEC 61000-4-2 Air) | ±15 kV | — |
| Bus Pin ESD Protection (IEC 61000-4-2 Contact) | [DATA_NEEDED: contact-discharge rating] | — |
| Unit Load | 1/8 (up to 256 nodes per bus) | — |
| Receiver Common-Mode Range | -7 V to +12 V | — |
| Fail-Safe Receiver | Full (logic-high on open/short/idle) | — |
| Bus Current (driver loaded) | +125 µA / -100 µA | — |
| Quiescent Supply Current | 510 µA (typical, no load) | — |
| Driver Enable | Yes (active-high, DE pin) | — |
| Receiver Enable | Yes (active-low, RE pin) | — |
| Boîtier | 8-MSOP (UZ) | 8-pin SOIC |
| Type de montage | Surface Mount | Surface mount |
| Statut RoHS | Compliant | [DATA_NEEDED: RoHS status] |
| Lead-Free / Halogen-Free | Yes (per Renesas product page) | — |
| Niveau MSL | [DATA_NEEDED: MSL rating] | — |
| Tension d'alimentation | — | 3.3 V |
| Maximum Data Rate | — | 20 Mbps |
| ESD Protection | — | ±20 kV |
| Transceiver Configuration | — | 1/1 half-duplex transceiver |
| Supported Standards | — | RS-422 and RS-485 |
| Driver Architecture | — | Slew-rate-limited differential driver |
| Receiver Architecture | — | Differential receiver |
| Number of Drivers | — | 1 |
| Number of Receivers | — | 1 |
| Direction Control | — | [DATA_NEEDED: transceiver direction-control method] |
| Plage de température de fonctionnement | — | [DATA_NEEDED: operating temperature range] |
| Courant d'alimentation | — | [DATA_NEEDED: supply current] |
| Propagation Delay | — | [DATA_NEEDED: driver and receiver propagation delay] |
| Common-Mode Voltage Range | — | [DATA_NEEDED: receiver common-mode voltage range] |
| Maximum Bus Load | — | [DATA_NEEDED: maximum unit loads per bus] |
| REACH Status | — | [DATA_NEEDED: REACH status] |