MAX3485ESA+T vs SN65HVD73DGS Comparaison
Comparaison détaillée côte à côte de MAX3485ESA+T par Analog Devices et SN65HVD73DGS par Texas Instruments. Comparez les spécifications clés, les paramètres électriques, le conditionnement, le statut de cycle de vie, les prix et la disponibilité pour déterminer le meilleur composant pour vos exigences de conception.
Analog Devices
MAX3485ESA+T - 10Mbps RS-485/RS-422 Transceiver | Analog Devices
MAX3485ESA+T ✓ ActifTexas Instruments
SN65HVD73DGS - 3.3V Full-Duplex RS-485 20Mbps | Texas Instruments
SN65HVD73DGS ✓ ActifComparaison des spécifications
| Paramètre | MAX3485ESA+T | SN65HVD73DGS |
|---|---|---|
| Marque | Analog Devices | Texas Instruments |
| Catégorie | Interface ICs | Interface ICs |
| Statut du cycle de vie | Actif | Actif |
| Product Type | RS-485/RS-422 transceiver | — |
| Tension d'alimentation | 3.3 V | — |
| Maximum Data Rate | 10 Mbps | — |
| Driver Count | 1 | — |
| Receiver Count | 1 | — |
| Duplex Mode | Half-duplex | — |
| Supported Standards | RS-422 and RS-485 | — |
| Boîtier | 8-SOIC | 10-VSSOP (DGS) 3.0 mm × 3.0 mm |
| Package Dimensions | 3.90 mm width | — |
| Type de montage | Surface mount | Surface Mount |
| Ordering Package | Tape and reel | — |
| Plage de température de fonctionnement | [DATA_NEEDED: operating temperature range] | — |
| Courant d'alimentation | [DATA_NEEDED: supply current] | — |
| Driver Propagation Delay | [DATA_NEEDED: driver propagation delay] | — |
| Receiver Propagation Delay | [DATA_NEEDED: receiver propagation delay] | — |
| ESD Protection | [DATA_NEEDED: ESD protection rating] | — |
| Common-Mode Voltage Range | [DATA_NEEDED: receiver common-mode voltage range] | -7 V to +12 V |
| RoHS Compliance | [DATA_NEEDED: RoHS compliance status] | — |
| REACH Compliance | [DATA_NEEDED: REACH compliance status] | — |
| Protocol | — | RS-422, RS-485 |
| Number of Drivers/Receivers | — | 1/1 |
| Duplex | — | Full |
| Supply Voltage (VCC) | — | 3 V to 3.6 V |
| Débit de données | — | 20 Mbps (max) |
| ESD Protection (Bus Pins) | — | 12 kV IEC 61000-4-2 contact discharge |
| Receiver Input Impedance | — | 1/8 unit load (up to 256 nodes) |
| Driver Enable | — | Yes, active-high (DE pin) |
| Receiver Enable | — | Yes, active-low (RE pin) |
| Température de fonctionnement | — | -40 °C to +125 °C |
| Niveau MSL | — | 2 |
| Statut RoHS | — | Compliant |