MAX485ESA+T vs SP485E Comparaison
Comparaison détaillée côte à côte de MAX485ESA+T par Analog Devices et SP485E par MaxLinear. Comparez les spécifications clés, les paramètres électriques, le conditionnement, le statut de cycle de vie, les prix et la disponibilité pour déterminer le meilleur composant pour vos exigences de conception.
MaxLinear
SP485E - Enhanced Low Power Half-Duplex RS-485/RS-422 Transceiver | MaxLinear
SP485E ✓ ActifComparaison des spécifications
| Paramètre | MAX485ESA+T | SP485E |
|---|---|---|
| Marque | Analog Devices | MaxLinear |
| Catégorie | Interface ICs | Interface ICs |
| Statut du cycle de vie | Actif | Actif |
| Product Type | RS-485/RS-422 transceiver | — |
| Transceiver Configuration | 1 driver and 1 receiver | — |
| Operating Mode | Half-duplex | — |
| Supply Voltage Range | 4.75 V to 5.25 V | — |
| Maximum Data Rate | 2.5 Mbps | — |
| Slew Rate Limiting | Not limited | — |
| Driver Short-Circuit Protection | Current limited and protected | — |
| Supported Standards | RS-485 and RS-422 | — |
| Boîtier | 8-pin SOIC | 8-pin NSOIC or PDIP |
| Package Pin Count | 8 pins | — |
| Type de montage | Surface mount | Surface Mount (NSOIC) or Through-Hole (PDIP) |
| Plage de température de fonctionnement | [DATA_NEEDED: operating temperature range] | [DATA_NEEDED: operating temperature] |
| Courant d'alimentation | [DATA_NEEDED: supply current] | — |
| Driver Output Current | [DATA_NEEDED: driver output current] | — |
| Receiver Input Sensitivity | [DATA_NEEDED: receiver input sensitivity] | ±200 mV |
| Common-Mode Voltage Range | [DATA_NEEDED: common-mode voltage range] | — |
| ESD Protection | [DATA_NEEDED: ESD protection rating] | — |
| Statut RoHS | unknown | Compliant |
| REACH Status | unknown | — |
| AEC-Q100 Qualification | unknown | — |
| Fonction | — | Transceiver |
| Protocol | — | RS-485, RS-422 |
| Number of Drivers/Receivers | — | 1/1 |
| Duplex | — | Half-duplex |
| Débit de données | — | 2.5 Mbps (max, SP485E non-slew-limited) |
| Supply Voltage (VCC) | — | 4.75 V to 5.25 V |
| Receiver Input Impedance | — | 12 kΩ minimum, 15 kΩ typical |
| Common-Mode Range | — | −7 V to +12 V |
| ESD Protection (HBM) | — | ±15 kV |
| ESD Protection (IEC 61000-4-2 Air Discharge) | — | ±15 kV |
| Process Technology | — | BiCMOS |
| Failsafe Receiver | — | Yes (open, shorted, idle bus) |
| Tri-State Enable Pins | — | Yes (DE, RE) |