SN65HVD78D vs SN65HVD77D Comparaison
Comparaison détaillée côte à côte de SN65HVD78D par Texas Instruments et SN65HVD77D par Texas Instruments. Comparez les spécifications clés, les paramètres électriques, le conditionnement, le statut de cycle de vie, les prix et la disponibilité pour déterminer le meilleur composant pour vos exigences de conception.
Texas Instruments
SN65HVD77D - 3.3V 50Mbps Full-Duplex RS-485 | Texas Instruments
SN65HVD77D ✓ ActifComparaison des spécifications
| Paramètre | SN65HVD78D | SN65HVD77D |
|---|---|---|
| Marque | Texas Instruments | Texas Instruments |
| Catégorie | USB Interface ICs | Interface ICs |
| Statut du cycle de vie | Actif | Actif |
| Product Type | 3.3 V half-duplex RS-485 transceiver | Full-duplex RS-485 transceiver |
| Supply Voltage Range | 3 V to 3.6 V | 3.0 V to 3.6 V |
| Nominal Supply Voltage | 3.3 V | 3.3 V |
| Maximum Signaling Rate | 50 Mbps | — |
| Driver Count | 1 | — |
| Receiver Count | 1 | — |
| Duplex Mode | Half-duplex | Full duplex |
| Bus Standard | RS-485 | — |
| Boîtier | 8-pin SOIC | 8-pin SOIC (D) |
| Plage de température de fonctionnement | -40°C to +125°C | -40°C to 125°C |
| Type de montage | Surface mount | Surface mount |
| ESD Protection | Human Body Model and IEC Contact Discharge on bus pins | ±12 kV IEC |
| IEC Contact Discharge Protection | ±12 kV | — |
| Fault Protection Voltage | -13 V to +16.5 V | — |
| Statut RoHS | [DATA_NEEDED: RoHS compliance status] | Compliant |
| REACH Status | [DATA_NEEDED: REACH compliance status] | — |
| AEC-Q100 Qualification | [DATA_NEEDED: AEC-Q100 qualification status] | — |
| Maximum Data Rate | — | 50 Mbps |
| Number of Drivers | — | 1 |
| Number of Receivers | — | 1 |
| Supported Standards | — | RS-485 and RS-422 |
| Package Width | — | 3.90 mm |
| External Enable Controls | — | None |
| Driver Output Type | — | Differential |
| Receiver Output Type | — | Single-ended logic output |
| Low-Power Standby Current | — | Less than 5 µA when driver and receiver are disabled |
| Termination Requirement | — | External termination required |