SN75176BDR vs SP485E Comparaison
Comparaison détaillée côte à côte de SN75176BDR par Texas Instruments et SP485E par MaxLinear. Comparez les spécifications clés, les paramètres électriques, le conditionnement, le statut de cycle de vie, les prix et la disponibilité pour déterminer le meilleur composant pour vos exigences de conception.
MaxLinear
SP485E - Enhanced Low Power Half-Duplex RS-485/RS-422 Transceiver | MaxLinear
SP485E ✓ ActifComparaison des spécifications
| Paramètre | SN75176BDR | SP485E |
|---|---|---|
| Marque | Texas Instruments | MaxLinear |
| Catégorie | Interface ICs | Interface ICs |
| Statut du cycle de vie | Actif | Actif |
| Statut du stock | In Stock | In Stock |
| Prix unitaire (USD) | $0,11 | $0,92 |
| Product Type | Differential bus transceiver | — |
| Tension d'alimentation | 5 V | — |
| Supported Standards | TIA/EIA-422-B and TIA/EIA-485-A | — |
| ITU Recommendations | V.11 and X.27 | — |
| Communication Mode | Bidirectional | — |
| Bus Architecture | Multipoint transmission | — |
| Transmission Line Type | Balanced transmission lines | — |
| Driver Output State | 3-state | — |
| Receiver Output State | 3-state | — |
| Plage de température de fonctionnement | 0 °C to 70 °C | [DATA_NEEDED: operating temperature] |
| Boîtier | SOIC (D), 8 pins | 8-pin NSOIC or PDIP |
| Type de montage | Surface mount | Surface Mount (NSOIC) or Through-Hole (PDIP) |
| Nombre de broches | 8 pins | — |
| Manufacturer | Texas Instruments | — |
| Statut RoHS | [DATA_NEEDED: RoHS status] | Compliant |
| REACH Status | [DATA_NEEDED: REACH status] | — |
| Automotive Qualification | [DATA_NEEDED: AEC-Q100 qualification] | — |
| Maximum Data Rate | [DATA_NEEDED: maximum data rate] | — |
| Input and Output Electrical Limits | [DATA_NEEDED: input and output electrical limits] | — |
| Propagation Delay | [DATA_NEEDED: propagation delay] | — |
| Courant de repos | [DATA_NEEDED: quiescent current] | — |
| Fonction | — | Transceiver |
| Protocol | — | RS-485, RS-422 |
| Number of Drivers/Receivers | — | 1/1 |
| Duplex | — | Half-duplex |
| Débit de données | — | 2.5 Mbps (max, SP485E non-slew-limited) |
| Supply Voltage (VCC) | — | 4.75 V to 5.25 V |
| Receiver Input Sensitivity | — | ±200 mV |
| Receiver Input Impedance | — | 12 kΩ minimum, 15 kΩ typical |
| Common-Mode Range | — | −7 V to +12 V |
| ESD Protection (HBM) | — | ±15 kV |
| ESD Protection (IEC 61000-4-2 Air Discharge) | — | ±15 kV |
| Process Technology | — | BiCMOS |
| Failsafe Receiver | — | Yes (open, shorted, idle bus) |
| Tri-State Enable Pins | — | Yes (DE, RE) |