SP485E vs SP485REP-L Comparaison
Comparaison détaillée côte à côte de SP485E par MaxLinear et SP485REP-L par Exar Corporation. Comparez les spécifications clés, les paramètres électriques, le conditionnement, le statut de cycle de vie, les prix et la disponibilité pour déterminer le meilleur composant pour vos exigences de conception.
MaxLinear
SP485E - Enhanced Low Power Half-Duplex RS-485/RS-422 Transceiver | MaxLinear
SP485E ✓ Actif
Comparaison des spécifications
| Paramètre | SP485E | SP485REP-L |
|---|---|---|
| Marque | MaxLinear | Exar Corporation |
| Catégorie | Interface ICs | Interface ICs |
| Statut du cycle de vie | Actif | Actif |
| Fonction | Transceiver | — |
| Protocol | RS-485, RS-422 | — |
| Number of Drivers/Receivers | 1/1 | — |
| Duplex | Half-duplex | — |
| Débit de données | 2.5 Mbps (max, SP485E non-slew-limited) | — |
| Supply Voltage (VCC) | 4.75 V to 5.25 V | — |
| Receiver Input Sensitivity | ±200 mV | — |
| Receiver Input Impedance | 12 kΩ minimum, 15 kΩ typical | 150 kOhm typical |
| Common-Mode Range | −7 V to +12 V | — |
| ESD Protection (HBM) | ±15 kV | — |
| ESD Protection (IEC 61000-4-2 Air Discharge) | ±15 kV | — |
| Plage de température de fonctionnement | [DATA_NEEDED: operating temperature] | — |
| Boîtier | 8-pin NSOIC or PDIP | 8-pin plastic DIP |
| Type de montage | Surface Mount (NSOIC) or Through-Hole (PDIP) | Through-hole |
| Process Technology | BiCMOS | — |
| Failsafe Receiver | Yes (open, shorted, idle bus) | — |
| Tri-State Enable Pins | Yes (DE, RE) | — |
| Statut RoHS | Compliant | [DATA_NEEDED: RoHS status] |
| Product Type | — | Half-duplex RS-485/RS-422 transceiver |
| Receiver Unit Load | — | 1/10 unit load |
| Supported Transceivers per Line | — | More than 400 transceivers |
| Supply Voltage Range | — | 4.75 V to 5.25 V |
| Propagation Delay | — | 60 ns |
| Minimum Operating Temperature | — | -40 C |
| Maximum Operating Temperature | — | +85 C |
| Duplex Configuration | — | Half-duplex |
| Supported Standards | — | RS-485 and RS-422 |
| Driver Configuration | — | 1/1 differential driver |
| REACH Status | — | [DATA_NEEDED: REACH status] |
| AEC-Q100 Qualification | — | [DATA_NEEDED: AEC-Q100 qualification] |
| Lead-Free Status | — | [DATA_NEEDED: lead-free status] |