EPC8QC100DM vs EPC8QI100N तुलना

विस्तृत दोनों ओर की तुलना EPC8QC100DM द्वारा Intel और EPC8QI100N द्वारा Altera. मुख्य विशेषताओं, इलेक्ट्रिकल पैरामीटर, पैकेजिंग, चक्र स्थिति, मूल्यांकन और उपलब्धता को तुलना करके अपनी डिजाइन की आवश्यकताओं के लिए सबसे अच्छा घटक निर्धारित करें。

विशेषता तुलना

पैरामीटर EPC8QC100DM EPC8QI100N
ब्रांड Intel Altera
श्रेणी EEPROM EEPROM
लाइफसाइकिल स्थिति Obsolete NRND
मेमोरी प्रकार Non-volatile configuration PROM —
मेमोरी आकार 8 Mb (1 MB) 8 Mbit (8,388,608 bits)
इंटरफ़ेस Serial (Passive Serial / Passive Parallel Synchronous / Active Serial) —
Supply Voltage (VCC) 3.0 V to 3.6 V (3.3 V typical) 3.0 V to 3.6 V
Maximum DCLK Frequency 40 MHz —
In-System Programming Yes (IEEE 1149.1 / IEEE 1532 JTAG) —
Cascade Support Yes - two EPC8 devices for 16 Mb —
ऑपरेटिंग तापमान -40 C to +85 C (industrial / DM suffix) -40 °C to +85 °C (Industrial)
पैकेज 100-PQFP (20 x 14 mm) 100-PQFP / 100-BQFP (20 x 14 mm)
माउंटिंग प्रकार Surface Mount Surface Mount
MSL स्तर 1 (Unlimited) —
RoHS स्थिति Compliant —
Lead-Free / Halogen-Free Lead-free (per supplier); halogen status not in datasheet excerpt —
Compatible FPGA Families Cyclone, Cyclone II, Cyclone III, Stratix, Arria —
Configuration Modes PS, PPS, AS (with appropriate FPGA master) —
Programming Cycles [DATA_NEEDED: minimum erase/write endurance cycles] —
Manufacturer — Altera (Intel)
Part Family — EPC8 (Enhanced Configuration)
Device Type — Configuration PROM for SRAM-based FPGAs
Programmable Type — In System Programmable (Flash)
Configuration Interface — Altera serial (4-wire: DATA, DCLK, nCS, nINIT_CONF)
Maximum Configuration Clock — 50 MHz
On-Chip Decompression — Yes (Altera compression algorithm)
पिन काउंट — 100
Lead-Free / RoHS — Yes (per distributor listings)
JTAG (IEEE 1149.1) ISP — Supported
Multi-Device Daisy-Chain — Supported
Target FPGA Families — ACEX 1K, APEX 20K, APEX II, Arria GX, Cyclone, Cyclone II, FLEX 10K, FLEX 6000, Mercury, Stratix, Stratix GX, Stratix II, Stratix II GX
Packaging — Tray

डेटाशीट और संसाधन

सभी उत्पादों को देखें BOM बनाएं कीट की अनुरोध