LM2903AQS-13
LM2903AQS-13 - Dual 36V AEC-Q100 Comparator | Diodes Inc
The Diodes Incorporated LM2903AQS-13 is an automotive-grade dual differential voltage comparator with a wide supply range of 2V to 36V on a single supply (or ±1V to ±18V on dual supplies), a typical input offset voltage of 1mV, and open-collector outputs in an 8-pin SOIC (SO-8) package qualified to AEC-Q100.
A voltage comparator is an analog building block that compares two input voltages and drives its output to indicate which is higher. Within the power-management and signal-conditioning hierarchy, comparators sit alongside operational amplifiers and voltage references; unlike an op-amp, a comparator is intentionally uncompensated for fastest switching and is used with an open-collector output stage to interface directly with TTL and CMOS logic.
Key features of the LM2903AQS-13 include very low input offset voltage (1mV typical), low input bias current of 25nA, and low supply current drain of approximately 0.6mA per comparator, which makes the device suitable for battery-powered designs. The common-mode input voltage range includes ground even when operated from a single supply, allowing the part to sense signals near 0V without an external negative rail.
The device belongs to the industry-standard LM2901Q/LM2903Q family from Diodes Incorporated. Outputs are open-collector, so pull-up resistors are required and multiple outputs can be wired-OR for window-comparator or over-voltage/under-voltage detection topologies. Rail-to-rail output swing to the positive rail is achieved through the external pull-up, and the output stage sinks current to ground with saturation voltage low enough to drive TTL logic directly.
Typical applications include automotive sensor monitoring and limit detection, over-voltage and under-voltage supervisors, window comparators on industrial 24V-rail systems, oscillator and Schmitt-trigger circuits, and battery-management threshold detection in portable equipment. The automotive qualification (AEC-Q100) makes it especially appropriate for in-vehicle modules exposed to -40C to +125C ambient conditions.
When designing with this part, remember that the open-collector output requires a pull-up resistor; the pull-up may be referenced to any voltage up to the 36V absolute maximum regardless of the comparator supply. Input common-mode range must be respected at the negative extreme, and hysteresis (a few millivolts via positive feedback) should be added when comparing slowly moving signals to prevent output chatter.
This page synthesizes distributor inventory listings, drop-in cross-reference data, and practical design notes not found in the manufacturer datasheet, providing a single quotable reference for sourcing and design engineers.
Permintaan RFG
Kontak