EPC16QI100TBAC vs EPC16QC100T 比較
詳細な並列比較: EPC16QI100TBAC メーカー: Altera および EPC16QC100T メーカー: Altera。主要仕様、電気的特性、パッケージ、ライフサイクルステータス、価格、在庫状況を比較して、設計要件に最適な部品を判断してください。
仕様比較
| パラメータ | EPC16QI100TBAC | EPC16QC100T |
|---|---|---|
| ブランド | Altera | Altera |
| カテゴリ | Memory ICs | Memory ICs |
| ライフサイクル状態 | ラストバイ | NRND |
| 在庫状況 | In Stock | In Stock |
| 単価（USD） | $15.95 | $17.95 |
| Memory Density | 16 Mbit (2 Mbyte) | — |
| メモリタイプ | Flash (Enhanced Configuration Device) | In-System Programmable Configuration PROM |
| 電源電圧 | 3.3 V | — |
| Configuration Modes | Passive Parallel Synchronous (PPS), Passive Parallel Asynchronous (PPA), Passive Serial (PS) | — |
| Maximum Configuration Clock | 40 MHz | — |
| Number of Configuration Pages | Up to 8 (selectable via PGM[2..0]) | — |
| パッケージ | 100-pin PQFP (20 x 14 mm) | PQFP-100 (20 x 14 mm) |
| In-System Programmable | Yes (via JTAG / IEEE 1149.1) | — |
| JTAG Support | Yes (IEEE 1149.1 boundary-scan and programming) | — |
| Supported FPGA Families | Altera Stratix, Cyclone, Arria series | — |
| Data Compression | Supported (15-30% density gain depending on target FPGA) | Built-in decompression engine (up to 35% expansion) |
| 動作温度 | -40C to +85C (industrial) | 0C to +70C (commercial) |
| 実装タイプ | Surface Mount (PQFP) | Surface Mount |
| MSLレベル | 3 (168 hours) | 3 (per JEDEC J-STD-020) |
| Lead-Free / RoHS | Lead-free (per JEDEC J-STD-020); RoHS compliance: [DATA_NEEDED] | Depends on date code; verify per lot |
| Dynamic Reconfiguration | Yes (page mode via PGM[2..0] pins) | — |
| Configuration Controller | Integrated | — |
| Programming Interface | JTAG / 4-wire passive serial | — |
| メモリサイズ | — | 16 Mbit |
| インターフェース | — | Serial FPGA configuration + JTAG (IEEE 1149.1) |
| Supply Voltage (VCC) | — | 3.3 V |
| Programmability | — | In-System Programmable via JTAG |
| Daisy-Chain Support | — | Yes (multi-device cascade) |
| FPGA Compatibility | — | Altera Cyclone, Stratix, ACEX, APEX series |
| Programming Cycles | — | 100 typical (per Altera datasheet) |
| Packaging Suffix | — | 'T' indicates Tape and Reel |
| Max DCLK Frequency | — | [DATA_NEEDED: max DCLK frequency] |
| Access Time | — | [DATA_NEEDED: serial access time] |