ISL83485IP vs SP485ES-L 比較
詳細な並列比較: ISL83485IP メーカー: Renesas Electronics および SP485ES-L メーカー: MaxLinear。主要仕様、電気的特性、パッケージ、ライフサイクルステータス、価格、在庫状況を比較して、設計要件に最適な部品を判断してください。
仕様比較
| パラメータ | ISL83485IP | SP485ES-L |
|---|---|---|
| ブランド | Renesas Electronics | MaxLinear |
| カテゴリ | Interface ICs | Interface ICs |
| ライフサイクル状態 | 有効 | 有効 |
| Product Type | RS-485/RS-422 transceiver | RS-485/RS-422 half-duplex transceiver |
| Transceiver Configuration | 1 driver / 1 receiver | 1/1 transceiver |
| Duplex Mode | Half duplex | Half duplex |
| 電源電圧 | 3.3 V | [DATA_NEEDED: supply voltage range] |
| Maximum Data Rate | 10 Mbps | 5000 kbps |
| Supported Standards | RS-485 and RS-422 | RS-485 and RS-422 |
| Process Technology | BiCMOS | — |
| Power Consumption Profile | Low power | — |
| Signal Type | Balanced differential | — |
| パッケージ | 8-pin PDIP | 8-PDIP |
| 実装タイプ | Through-hole | Through-hole |
| Driver Enable Control | [DATA_NEEDED: driver enable logic polarity and pin assignment] | — |
| Receiver Enable Control | [DATA_NEEDED: receiver enable logic polarity and pin assignment] | — |
| 動作温度範囲 | [DATA_NEEDED: operating temperature range] | -40 C to +85 C |
| Maximum Supply Voltage | [DATA_NEEDED: maximum supply voltage] | — |
| Common-Mode Voltage Range | [DATA_NEEDED: common-mode voltage range] | [DATA_NEEDED: receiver common-mode voltage range] |
| Differential Input Sensitivity | [DATA_NEEDED: differential receiver sensitivity] | — |
| Maximum Driver Output Current | [DATA_NEEDED: maximum driver output current] | — |
| 電源電流 | [DATA_NEEDED: typical and maximum supply current] | [DATA_NEEDED: typical and maximum supply current] |
| ESD Protection Rating | [DATA_NEEDED: ESD protection rating] | [DATA_NEEDED: ESD protection rating] |
| RoHS ステータス | [DATA_NEEDED: RoHS compliance status] | unknown |
| REACH Status | [DATA_NEEDED: REACH compliance status] | unknown |
| Number of Drivers | — | 1 driver |
| Number of Receivers | — | 1 receiver |
| Logic Technology | — | BiCMOS |
| ピン数 | — | 8 pins |
| Driver Output Current | — | [DATA_NEEDED: driver output current] |
| Receiver Input Resistance | — | [DATA_NEEDED: receiver input resistance] |
| AEC-Q100 Status | — | not_applicable |