NE5534N vs NE5534DRG4 比較
詳細な並列比較: NE5534N メーカー: onsemi および NE5534DRG4 メーカー: Texas Instruments。主要仕様、電気的特性、パッケージ、ライフサイクルステータス、価格、在庫状況を比較して、設計要件に最適な部品を判断してください。
仕様比較
| パラメータ | NE5534N | NE5534DRG4 |
|---|---|---|
| ブランド | onsemi | Texas Instruments |
| カテゴリ | Amplifier ICs | Amplifier ICs |
| ライフサイクル状態 | Unknown | Unknown |
| Product Type | Single operational amplifier | — |
| Amplifier Type | General Purpose | Single low-noise operational amplifier |
| Number of Circuits | 1 circuit | — |
| Maximum Supply Voltage | 30 V | — |
| Gain-Bandwidth Product | 10 MHz | — |
| Slew Rate | 13 V/us | 13 V/µs typical |
| パッケージ | 8-PDIP, 0.300 inch pitch | 8-SOIC |
| 実装タイプ | Through-hole | Surface mount |
| ピン数 | 8 pins | — |
| Supplier | onsemi | — |
| Primary Application | Audio applications | — |
| Noise Performance | Low noise | — |
| Output Drive Capability | High | — |
| Small-Signal Bandwidth | [DATA_NEEDED: small-signal bandwidth] | — |
| 電源電流 | [DATA_NEEDED: supply current] | — |
| Input Offset Voltage | [DATA_NEEDED: input offset voltage] | [DATA_NEEDED: input offset voltage] |
| Input Bias Current | [DATA_NEEDED: input bias current] | [DATA_NEEDED: input bias current] |
| Common-Mode Input Range | [DATA_NEEDED: common-mode input range] | — |
| Output Swing | [DATA_NEEDED: output swing] | — |
| Unity-Gain Stability | [DATA_NEEDED: unity-gain stability] | — |
| 動作温度範囲 | [DATA_NEEDED: operating temperature range] | [DATA_NEEDED: operating temperature range] |
| RoHS ステータス | [DATA_NEEDED: RoHS status] | unknown |
| REACH Status | [DATA_NEEDED: REACH status] | unknown |
| Noise Voltage Density | — | 3.5 nV/√Hz typical |
| Unity-Gain Bandwidth | — | 10 MHz typical |
| Common-Mode Rejection Ratio | — | 100 dB typical |
| High DC Voltage Gain | — | 100 dB typical |
| Peak-to-Peak Output Voltage Swing | — | 100 V/mV typical under cited conditions |
| Supply Voltage Range | — | Wide supply-voltage range; exact limits [DATA_NEEDED: supply voltage range] |
| Circuit Count | — | 1 circuit |
| Package Width | — | 0.154 inch / 3.90 mm |
| Output Current | — | [DATA_NEEDED: output current] |