LM111-LM211
LM111-LM211 - High-Speed Differential Comparator | Texas Instruments
The Texas Instruments LM111-LM211 is a family designation for single, high-speed differential voltage comparators designed to operate from wide power-supply ranges, including ±15 V operational-amplifier supplies and single +5 V logic supplies. The comparator combines low input current with an open-collector output whose logic levels are compatible with many TTL and MOS circuits. The available ordering variants include LM111, LM211, and LM311 devices documented by the manufacturer under the LM111, LM211, and LM311 differential comparator datasheet.
A voltage comparator is an analog integrated circuit that compares two input voltages and produces a digital logic state indicating which input is higher. In the broader electronics hierarchy, a differential comparator belongs to comparator ICs, analog-to-digital decision interfaces, and signal-conditioning semiconductors. It is commonly used where a sensor, reference voltage, timing ramp, or control signal must be translated into a logic-level event.
The LM111, LM211, and LM311 devices are described by Texas Instruments as single high-speed voltage comparators. Their low input currents are useful when the driving source has high impedance or when input bias current could otherwise create measurement errors. The family supports conventional ±15 V supplies and +5 V logic-system operation, making it suitable for legacy analog, control, timing, and industrial interface circuits. Output levels are compatible with most TTL and MOS circuits, although the open-collector output requires an appropriate pull-up arrangement.
The LM111, LM211, and LM311 differ primarily in their specified operating-temperature families: TI identifies the LM111-N as specified from −55°C to +125°C, the LM211-N from −25°C to +85°C, and the LM311-N from 0°C to +70°C. The target string LM111-LM211 is therefore a family or ordering designation rather than one uniquely specified package-and-temperature variant. The exact commercial suffix, package, pin configuration, and current availability must be confirmed against the selected manufacturer orderable part.
Typical uses include precision voltage thresholding, zero-crossing detection, peak detection, window comparison, pulse timing, sensor interface conditioning, and control logic interfacing. The comparator is placed between a signal source and a downstream TTL or MOS input, with its output configured to drive the receiving device through a suitable pull-up or interface network. Engineers should verify supply polarity, input common-mode limits, output pull-up voltage, switching behavior, and input offset requirements in the manufacturer datasheet before layout release.
The key design consideration is that an open-collector comparator is not a push-pull logic driver. The output node floats when the device is off, so the external pull-up resistor, pull-up voltage, load capacitance, and required logic rise time must be selected together. Input filtering and grounding are also important when the comparator is used near precision thresholds or noisy switching nodes. This page distinguishes verified family-level facts from parameters that require a specific package and orderable suffix.
This page synthesizes the verified manufacturer and distributor references for the LM111-LM211 family, separates documented family-level capabilities from orderable-device requirements, and highlights the design decisions that determine whether an open-collector comparator is suitable in a given circuit. The alternatives listed here are limited to parts explicitly supported as same-family or comparator cross-reference candidates; exact replacement must be checked against the selected package and suffix.
RFC
Hubungi kami