LM2903Q2T
LM2903Q2T - Dual Low-Power Voltage Comparator | STMicroelectronics
STMicroelectronics LM2903Q2T is a dual, independent, low-power voltage comparator designed for single-supply or split-supply operation across a wide voltage range. The device is identified as a standard general-purpose comparator with open-collector, rail-to-rail outputs and is packaged in an 8-DFN 2 x 2 mm package. Its two comparator channels can be used separately or together for threshold detection, overvoltage and undervoltage monitoring, signal conditioning, and basic analog control functions.
A voltage comparator is an analog mixed-signal IC that compares an input voltage with a reference voltage and changes its output state when the relationship between those voltages changes. The LM2903 belongs to the comparator hierarchy, which sits between general-purpose analog signal conditioning and system-level protection or control. Its open-collector outputs can be pulled up to a suitable supply rail, allowing interface compatibility with TTL, CMOS, MOS, and other digital logic when the output circuit is designed correctly.
The LM2903Q2T is specifically suited to low-power applications because the manufacturer identifies it as a low-power dual comparator. Its two independent channels provide flexibility in battery-operated equipment, industrial sensing, automotive electronics, consumer products, and embedded control systems. The 2 x 2 mm DFN package also supports compact layouts where board area is limited, although its exposed thermal pad and fine-pitch assembly requirements require careful PCB design.
The comparator output architecture is open collector, so an external pull-up resistor is generally required to establish a high output level. The output transistor can sink current when the comparator condition is met, while the pull-up network determines the high-state voltage and rise time. This configuration is useful for wired-AND signal aggregation, but it also means that the output voltage, transition timing, and allowable sink current depend on the external resistor and load.
The LM2903 family is designed for operation from a single supply or split supplies, making it appropriate for systems that require comparison of signals referenced to ground or signals that exceed ground when both positive and negative rails are available. Because the exact electrical limits, common-mode range, output timing, and automotive qualification details are not shown in the retrieved product summaries, final circuit design should use the manufacturer datasheet and its recommended operating conditions.
A compact application should include local input filtering when sensor leads are long or noisy, a defined output pull-up, and adequate copper around the exposed pad when both channels operate continuously. The small DFN package can reduce board space, but its compact size does not eliminate thermal or assembly constraints. Use the manufacturer pin configuration and land pattern when assigning inputs, outputs, supply pins, and the exposed pad.
This page combines the LM2903Q2T product identity, verified manufacturer and distributor references, application guidance, package considerations, and design notes. It also explains why open-collector operation, power-supply topology, output pull-up design, and thermal layout determine whether the comparator works reliably in a real system.
RFC
Hubungi kami