MCP25025T-I/SL
MCP25025T-I/SL - 8-Input CAN I/O Expander | Microchip
The Microchip Technology MCP25025T-I/SL is an 8-I/O CAN input/output expander with a configurable 1-Wire line-driver option, two PWM outputs, and a 4 MHz clock in a 14-pin SOIC package. According to the verified product data, it accepts a 2.7 V to 5.5 V supply and provides push-pull output stages capable of 25 mA source or sink current. These headline specifications position the device for distributed embedded control, CAN-connected sensing, actuator interfaces, and systems that need additional digital I/O beyond a host microcontroller.
A CAN I/O expander is a peripheral that extends a host controller's digital input and output capability over a serial bus. It sits between a CAN-capable microcontroller or CAN transceiver and external switches, indicators, sensors, and actuators. The target belongs to the broader interface-IC and I/O-expander hierarchy: it combines a CAN receiver, digital input conditioning, configurable output drivers, PWM capability, EEPROM, and power-on reset in one device. This integration reduces external logic when a design needs remote I/O nodes connected to a CAN network.
Verified features include up to 8 digital I/O lines, up to 2 PWM outputs, three transmit buffers, two receive buffers, one mask, and two CAN filters. The device also includes EEPROM, power-on reset, and no interrupt output. Its 4 MHz clock supports the internal CAN and serial functions, while the 2.7 V to 5.5 V range supports both lower-voltage and 5 V embedded systems when the surrounding interface levels are compatible.
The MCP25025 family is intended for CAN-connected embedded applications where a central controller must monitor inputs and drive remote outputs without placing every I/O pin on the main processor. The configurable I/O architecture allows the design to use lines as inputs or outputs. Push-pull operation is useful for digital loads that need a actively driven signal, while the stated 25 mA source or sink capability sets a firm boundary for LED, relay-driver, or other load designs.
Typical uses include industrial CAN control modules, building automation endpoints, vehicle accessory controllers, remote sensor nodes, actuator concentrators, and small PLC-style interface boards. The device is especially useful where a CAN bus already exists and adding another controller would be unnecessary. Firmware must configure the GPIO and CAN behavior, and the host must also provide the physical CAN transceiver unless the connected interface arrangement already includes one.
Designers should verify absolute maximum voltages, pin-specific input thresholds, output timing, reset behavior, and transceiver compatibility against the manufacturer datasheet before layout release. Keep the CAN and 1-Wire signal paths away from noisy switching nodes, provide the required bypass capacitance close to the supply pins, and check that each driven load remains below 25 mA. The 14-SOIC package is leaded and easy to inspect, but board area is larger than an equivalent fine-pitch surface-mount package.
This page combines verified distributor specifications, manufacturer positioning, interface hierarchy, application guidance, and replacement constraints. Its practical value is the separation between confirmed specifications and unverified parameters, helping engineers move from part selection to schematic review without treating unsupported assumptions as datasheet facts.
RFC
Hubungi kami