PCA9564D vs PCA9555DBR Pengandingan
Pengandingan Sisi Kiri Sisi Kanan Terperinci PCA9564D disebabkan oleh NXP Semiconductors dan PCA9555DBR disebabkan oleh NXP Semiconductors. Bandingkan spesifikasi utama, parameter elektrik, pakej, status kehidupan, harga, dan keupayaan untuk menentukan komponen terbaik untuk keperluan disenjaya anda.
NXP Semiconductors
PCA9564D - 400 kHz Parallel-to-I2C Controller | NXP Semiconductors
PCA9564D ✓ AktifNXP Semiconductors
PCA9555DBR - 16-Bit I2C GPIO Expander with Interrupt | NXP (Tape & Reel)
PCA9555DBR ✓ AktifPengandingan Spesifikasi
| Parametr | PCA9564D | PCA9555DBR |
|---|---|---|
| Merek | NXP Semiconductors | NXP Semiconductors |
| Kategori | Interface ICs | Interface ICs |
| Status Lingkungan Hidup | Aktif | Aktif |
| Controller Type | Parallel bus to I2C bus controller | — |
| Parallel Interface | 8-bit parallel bus | — |
| Serial Interface | I2C bus | — |
| Supply Voltage Range | 2.3 V to 3.6 V | — |
| Nominal Supply Voltage | 2.5 V or 3.3 V | — |
| Arus Pemberi Arus | 6 mA | — |
| Maximum I2C Bus Frequency | 400 kHz | — |
| Kemasan | 20-pin SO, 7.50 mm width | — |
| Package Type | SOIC-20 | SSOP-24 |
| Jenis Pemasangan | Surface mount | Surface mount |
| Bilangan Pin | 20 | — |
| Gambaran Suhu Operasi | [DATA_NEEDED: operating temperature range] | [DATA_NEEDED: operating temperature range] |
| I2C Address Configuration | [DATA_NEEDED: programmable I2C address range and configuration method] | — |
| Parallel Data Width | 8 bits | — |
| I2C Addressing | [DATA_NEEDED: supported addressing modes] | — |
| Status RoHS | [DATA_NEEDED: RoHS compliance status] | unknown |
| REACH Status | [DATA_NEEDED: REACH compliance status] | unknown |
| AEC-Q100 Qualification | [DATA_NEEDED: AEC-Q100 qualification status] | [DATA_NEEDED: automotive qualification status] |
| Device Type | — | 16-bit I2C/SMBus GPIO expander with interrupt |
| GPIO Count | — | 16 bits |
| Operating Voltage Range | — | 2.3 V to 5.5 V |
| I2C Maximum Frequency | — | 400 kHz |
| I2C/SMBus Interface | — | Two-wire serial interface |
| I/O Port Configuration | — | Input or output per bit |
| I/O Port Tolerance | — | 5 V tolerant |
| Interrupt Output | — | Active-low, open-drain |
| Standby Current | — | 1 uA maximum |
| Package Pitch | — | 1.0 mm |
| Device Pin Count | — | 24 pins |
| Serial Addressing | — | Seven-bit I2C address; [DATA_NEEDED: address table] |