EPC1PC8 vs EPC1PCB Karşılaştırma
Ayrıntılı yan yana karşılaştırma EPC1PC8 tarafından Altera ve EPC1PCB tarafından IntelAnahtar özellikleri, elektriksel parametreleri, ambalajı, yaşam döngüsü durumu, fiyatlandırma ve mevcudiyeti karşılaştırarak tasarım gereksinimleriniz için en iyi bileşeni belirleyin.
Özellik Karşılaştırması
| Parametre | EPC1PC8 | EPC1PCB |
|---|---|---|
| Marka | Altera | Intel |
| Kategori | Memory ICs | FPGA & CPLD |
| Yaşam Döngüsü Durumu | Obsolete | NRND |
| Bellek Türü | OTP Configuration PROM (Non-volatile) | — |
| Bellek Boyutu | 1 Mbit (1,048,576 bits) | — |
| Supply Voltage (VCC) | 5.0 V (typical) | — |
| Configuration Interface | Altera proprietary serial (DATA, DCLK, OE, nCS) | — |
| Programmability | One-Time Programmable (OTP) | — |
| Paket | 8-pin PDIP (8-PDIP, 300 mil) | PLCC-20 (Plastic Leaded Chip Carrier) |
| Montaj Türü | Through-Hole (THT) | Surface Mount (socket-compatible) |
| Target FPGAs | ACEX 1K, APEX 20K/20KE/20KC, FLEX 10K/10KE/10KA, FLEX 6000/A | — |
| Pin Pitch | 2.54 mm (0.100 in) | — |
| İşletim Sıcaklığı | 0 C to +70 C (commercial) [DATA_NEEDED: full min/max range] | — |
| Programming Hardware | Altera MasterBlaster / ByteBlaster (legacy programmer) | — |
| Configuration Mode | Serial (1-bit data, 1-bit clock) | — |
| RoHS Durumu | [DATA_NEEDED: RoHS compliance status] | [DATA_NEEDED: lead-free/RoHS status] |
| Lead-Free | [DATA_NEEDED: lead-free / SnPb plating] | — |
| MSL Seviyesi | [DATA_NEEDED: moisture sensitivity level] | — |
| Product Type | — | Enhanced Configuration Device for SRAM-based FPGAs |
| Memory Density | — | 1 Mbit |
| Program Memory Type | — | Flash (non-volatile) |
| Configuration Modes Supported | — | FPP (Fast Passive Parallel), PS (Passive Serial) |
| Supply Voltage VCC | — | 3.3 V |
| I/O Voltage Tolerance | — | 5.0 V tolerant |
| Supported FPGA Families | — | APEX, FLEX, ACEX, Cyclone, Stratix |
| Arayüz | — | Altera configuration bus (DATA, DCLK, nCONFIG, nSTATUS, CONF_DONE) |
| Multi-Device Daisy Chain | — | Yes (nCASC, nCS pins) |
| Programming Interface | — | JTAG (IEEE 1149.1 boundary scan) |
| In-System Programmable | — | Yes |
| Program/Erase Endurance | — | [DATA_NEEDED: program/erase cycles] |
| Data Retention | — | [DATA_NEEDED: data retention years] |