INA103KP vs INA103KPG4 Karşılaştırma
Ayrıntılı yan yana karşılaştırma INA103KP tarafından Texas Instruments ve INA103KPG4 tarafından Texas InstrumentsAnahtar özellikleri, elektriksel parametreleri, ambalajı, yaşam döngüsü durumu, fiyatlandırma ve mevcudiyeti karşılaştırarak tasarım gereksinimleriniz için en iyi bileşeni belirleyin.
Özellik Karşılaştırması
| Parametre | INA103KP | INA103KPG4 |
|---|---|---|
| Marka | Texas Instruments | Texas Instruments |
| Kategori | Amplifier ICs | Amplifier ICs |
| Yaşam Döngüsü Durumu | Aktif | Aktif |
| Product Type | Low-noise, low-distortion instrumentation amplifier | Low-noise, low-distortion instrumentation amplifier |
| Number of Amplifiers | 1 circuit | — |
| Gain-Bandwidth Product | 6 MHz | 1000 MHz |
| Input Noise Density | 1 nV/√Hz | 1 nV/√Hz |
| Common-Mode Rejection Ratio | >100 dB | >100 dB |
| Supply Voltage Range | ±25 V | ±25 V |
| Recommended Source Impedance | 200 Ω | — |
| Architecture | Current-feedback circuitry | — |
| Gain-Setting Resistors | Internal, 100 Ω | — |
| Paket | 16-pin PDIP | 16-pin PDIP |
| Package Pitch | 7.62 mm (0.300 inch) | — |
| Montaj Türü | Through-hole | Through-hole |
| Signal Type | Differential low-level analog signal | — |
| Primary Application | Balanced low-impedance microphone signal acquisition | — |
| Total Harmonic Distortion plus Noise | [DATA_NEEDED: THD+N value and test conditions] | 100 |
| İşletim Sıcaklığı Aralığı | [DATA_NEEDED: operating temperature range] | [DATA_NEEDED: operating temperature range] |
| RoHS Compliance | [DATA_NEEDED: RoHS compliance status] | — |
| REACH Compliance | [DATA_NEEDED: REACH compliance status] | — |
| Number of Circuits | — | 1 circuit |
| Internal Gain-Setting Resistors | — | 100 kΩ |
| Maximum Output Voltage | — | ±10 V |
| Maksimum Çıkış Akımı | — | 2.5 mA |
| Gain Accuracy | — | 0.02% |
| Signal Input Type | — | Differential |
| RoHS Durumu | — | [DATA_NEEDED: RoHS status] |
| Output Offset Voltage | — | [DATA_NEEDED: output offset voltage] |
| Input Bias Current | — | [DATA_NEEDED: input bias current] |
| Slew Rate | — | [DATA_NEEDED: slew rate] |