ADM4852AR vs ADM485AR So sánh

So sánh chi tiết song song của ADM4852AR bằng Analog Devices và ADM485AR bằng Analog Devices. So sánh các thông số quan trọng, thông số điện tử, gói gọn, trạng thái vòng đời, giá cả và khả năng cung cấp để xác định linh kiện tốt nhất cho yêu cầu thiết kế của bạn.

Analog Devices
ADM4852AR ADM4852AR - 2.5Mbps RS-485 Transceiver | Analog Devices

ADM4852AR - 2.5Mbps RS-485 Transceiver | Analog Devices

ADM4852AR ✓ Hoạt động
Analog Devices
ADM485AR ADM485AR - Low-Power RS-485/RS-422 Transceiver | Analog Devices

ADM485AR - Low-Power RS-485/RS-422 Transceiver | Analog Devices

ADM485AR ✓ Hoạt động

So sánh thông số kỹ thuật

Tham số ADM4852AR ADM485AR
Thương hiệu Analog Devices Analog Devices
Danh mục Interface ICs Interface ICs
Trạng thái vòng đời Hoạt động Hoạt động
Product Type RS-485/RS-422 differential line transceiver Differential line transceiver
Điện áp cung cấp 5 V 5 V
Maximum Data Rate 2.5 Mbps [DATA_NEEDED: maximum data rate]
Communication Modes Half-duplex and full-duplex —
Standards Compatibility EIA RS-485 and RS-422 —
Slew Rate Limited —
Fail-Safe Receiver True fail-safe —
Bus Topology Multipoint bus transmission lines —
Hộp 8-lead SOIC 8-pin SOIC
Kiểu lắp đặt Surface mount [DATA_NEEDED: surface-mount or through-hole mounting]
Số lượng chân 8 pins —
Khoảng nhiệt độ hoạt động [DATA_NEEDED: operating temperature range] [DATA_NEEDED: operating temperature range]
Driver Output Current [DATA_NEEDED: driver output current] —
Receiver Differential Threshold [DATA_NEEDED: receiver differential threshold] —
Propagation Delay [DATA_NEEDED: propagation delay] [DATA_NEEDED: propagation delay]
Điện áp yên tĩnh [DATA_NEEDED: quiescent current] —
Common-Mode Rejection [DATA_NEEDED: common-mode rejection] —
Trạng thái RoHS [DATA_NEEDED: RoHS status] —
REACH Status [DATA_NEEDED: REACH status] —
AEC-Q100 Qualification [DATA_NEEDED: AEC-Q100 qualification] —
Supported Standards — EIA RS-485 and RS-422
Driver Count — 1
Receiver Count — 1
Communication Mode — High-speed bidirectional
Bus Architecture — Multipoint balanced transmission line
Driver and Receiver Enable — Driver and receiver can be enabled
Signal Type — Differential balanced signaling
Logic Interface — [DATA_NEEDED: logic input and output voltage levels]
Differential Driver Output — [DATA_NEEDED: differential output voltage and current]
Receiver Sensitivity — [DATA_NEEDED: receiver sensitivity]
Common-Mode Voltage Range — [DATA_NEEDED: common-mode voltage range]
ESD Protection — [DATA_NEEDED: ESD protection rating]
RoHS — unknown
REACH — unknown
AEC-Q100 — unknown

Hồ sơ kỹ thuật & Tài nguyên

Xem tất cả sản phẩm Tạo BOM Yêu cầu báo giá