MSC8101M1500F
MSC8101M1500F - 300MHz SC140 DSP with EFCOP, 332-FCBGA | NXP
The NXP MSC8101M1500F is a network-ready digital signal processor (DSP) based on the SC140 core, running at 300 MHz and packaged in a 332-ball FCBGA (17x17 mm). It integrates a Communications Processor Module (CPM), 512 kB of on-chip RAM, and the Enhanced Filter Coprocessor (EFCOP) to accelerate channel filtering, packet classification, and cryptographic workloads common in wired and wireless networking infrastructure.
A digital signal processor is a specialized microprocessor whose architecture is optimized for the repetitive, multiply-accumulate arithmetic at the heart of real-time signal processing. Unlike general-purpose CPUs, a DSP exposes parallel MAC units, deterministic instruction timing, dedicated address generators, and tightly coupled memory so that filters, modems, vocoders, and protocol stacks run at line rate. The MSC8101 belongs to the SC140 family, an extension of the StarCore line, positioned as a network-ready DSP - that is, a programmable DSP that is paired with on-chip peripherals (CPM, EFCOP, multi-channel DMA) so it can be deployed as a single-chip modem, channel card, or protocol accelerator. The SC140 lineage sits inside the broader taxonomy: DSP -> programmable signal processor -> embedded processor -> integrated circuit.
Key features of the MSC8101M1500F include a 300 MHz core clock, the EFCOP hardware filter coprocessor for Viterbi, turbo, and finite-impulse-response acceleration, 512 kB of internal SRAM, an integrated CPM with serial interfaces for TDM/H.110-style streams, and a Host Interface that allows a host CPU to offload packet-processing tasks. The 332-FCBGA (17x17) package provides high signal density while remaining compatible with standard surface-mount assembly lines that support large BGA pitches.
Architecturally, the SC140 core combines four data ALUs and two address generation units driven by a single instruction stream, allowing up to four multiply-accumulates per cycle. Combined with the EFCOP and the CPM, the device can sustain full-duplex voice channels, multi-channel DSL front-ends, or backplane traffic shaping without external coprocessors. The 512 kB SRAM is split into M1 (instruction/boot), M2 (data), and M3/DDR-style external regions so that designers can map code and packet buffers without external memory thrash.
Typical deployments include channel banks and digital trunking in legacy TDM/VoIP gateways, multi-channel V.90/xDSL modems, packet processing line cards for SONET/SDH and Gigabit Ethernet routers, and security accelerators (IPsec/SSL bulk data paths) where the EFCOP accelerates bulk encryption primitives. It is also seen in industrial imaging and sonar front-ends where deterministic DSP cycles are required.
When designing with this part, pay close attention to PCB layout for the 332-ball FCBGA: use standard BGA escape routing, controlled-impedance traces for the Host Interface and DDR region, and a solid ground/power plane stack-up to meet signal-integrity targets. Note that this device has reached the end of its product lifecycle and should be considered primarily for legacy maintenance and form-fit-function replacements rather than new designs.
This page synthesizes distributor inventory, the SC140-family pin-compatible alternatives, and design guidance for the MSC8101M1500F in a single, decision-ready view not found in the original manufacturer datasheet.
詢價
聯絡我們