ATK-LORA-02 vs ATK-LORA-01 对比
详细并排对比 ATK-LORA-02 出自 ALIENTEK 和 ATK-LORA-01 出自 ALIENTEK。对比关键规格、电气参数、封装、生命周期状态、价格和供货情况，以确定最适合您设计需求的元器件。
规格对比
| 参数 | ATK-LORA-02 | ATK-LORA-01 |
|---|---|---|
| 品牌 | ALIENTEK | ALIENTEK |
| 分类 | RF Modules | RF Modules |
| 生命周期状态 | Obsolete | 有效 |
| 库存状态 | 有库存 | 有库存 |
| 单价（USD） | $5.40 | $5.50 |
| Manufacturer | ALIENTEK (ZhengDianYuanZi) | — |
| Module Type | LoRa wireless serial port module | LoRa wireless serial (UART) module |
| RF Chipset | [DATA_NEEDED: chipset family] | — |
| Operating Frequency | [DATA_NEEDED: sub-GHz ISM band] | 410 MHz to 441 MHz |
| Modulation | LoRa CSS chirp spread spectrum | LoRa (CSS) / FSK / OOK |
| Tx Power | up to +20 dBm (100 mW) | — |
| Rx Sensitivity | -120 dBm or better (low data rate) | — |
| Air Data Rate | 0.3 kbps to 62.5 kbps | — |
| Spreading Factors | 6 levels (SF6-SF12) | — |
| Bandwidth | 7.8 kHz to 500 kHz | — |
| Host Interface | UART (TXD/RXD), MD0, AUX, 3.3V TTL | — |
| Operating Voltage | 3.3 V DC typical | — |
| Package / Dimensions | SMD-15, 17 x 24 mm | — |
| 工作温度 | -40C to +85C | -40 to +85 C [DATA_NEEDED: confirm from official datasheet] |
| Range (Line-of-Sight) | [DATA_NEEDED: spec range value] | — |
| Configuration | AT command set over UART | — |
| Max Packet Size | 256 bytes | — |
| 安装类型 | Surface Mount (SMD) | Through-hole pin header (DIP-style breakout) |
| RoHS 状态 | Compliant (per JLCPCB listing) | — |
| RF Chip | — | Semtech SX1278 |
| Channel Step | — | 1 MHz (32 channels) |
| Air Data Rate (max) | — | 19200 bps |
| Communication Range | — | 3000 m (line-of-sight, open field) |
| Transmit Power | — | Up to +20 dBm (100 mW) |
| Receive Sensitivity | — | -137 dBm at SF6/SF7 BW=125 kHz [DATA_NEEDED: confirm exact SF/BW condition from datasheet] |
| 接口 | — | UART (TTL) - TXD, RXD |
| Default UART Baud | — | 9600 bps |
| 电源电压 | — | 3.3 V to 5 V DC |
| Module Size | — | 36 mm x 20 mm |
| Antenna Connector | — | SMA + optional IPEX pad |
| Encryption | — | AES-128 hardware |
| Spreading Factor | — | SF6 to SF12 (configurable via AT commands) |