MC9S12D64VPV
MC9S12D64VPV - 16-Bit 64KB Flash MCU | NXP | Automotive
The NXP Semiconductors MC9S12D64VPV is a 16-bit HCS12 automotive multiplexing microcontroller with 64KB of flash memory, 4KB of RAM, 1KB of EEPROM, and a 25MHz operating frequency, supplied in a 112-terminal LQFP package. Its operating voltage is 2.35V to 5.25V, while the industrial temperature range extends from -40°C to +105°C. These headline characteristics position the device for embedded automotive, industrial, and communications designs requiring deterministic 16-bit control with integrated flash and EEPROM memory.
A microcontroller is a programmable semiconductor that integrates a processor core, memory, and peripherals into one component. The MC9S12D64 belongs to the HCS12 family, whose 16-bit architecture, mixed-signal peripherals, and automotive-oriented interfaces support applications that need more control capability than a basic 8-bit device. The S12D family also provides an upward migration path from earlier 68HC08, 68HC11, and 68HC12 architectures by combining greater memory, additional peripherals, and higher performance.
The MC9S12D64VPV integrates 64KB of flash program memory, 4KB of RAM, and 1KB of EEPROM into a single package. Its 10-bit ADC resources and 25MHz maximum clock support mixed-signal control systems where sensor acquisition, communications, and real-time control coexist. The broad 2.35V to 5.25V operating range permits design flexibility across automotive and industrial voltage environments, while the -40°C to +105°C rating supports operation across extended temperature conditions.
Within the S12D family, devices are designed with package and peripheral compatibility to support scalable platform development. The family documentation describes fully pin-compatible members with selectable memory and peripheral options, allowing a common hardware concept to move between configurations as requirements change. The MC9S12D64VPV uses a square 20mm by 20mm LQFP-112 package with gull-wing terminals, providing a high pin count for analog interfaces, communication channels, timers, and control signals.
Typical applications include automotive body and multiplexing controllers, sensor-interface modules, industrial acquisition equipment, communication nodes, and embedded control platforms. Its 16-bit processing core is useful for algorithms requiring more arithmetic range than an 8-bit microcontroller, while the integrated ADC supports direct analog measurement. Designers should also consider the comparatively high 25MHz clock when evaluating timing margins, power consumption, and peripheral clock requirements.
PCB implementation requires careful attention to the 112-terminal LQFP footprint, exposed supply routing, decoupling, and signal integrity. Place input and output decoupling capacitors close to the appropriate supply terminals, use a continuous ground plane, and route high-frequency or communication signals away from switching nodes. Firmware, clock, reset, and power-management configuration must be checked against the device user guide before production release.
This product page combines the manufacturer-family identity, verified package and memory characteristics, practical automotive and industrial use cases, package-aware comparison information, and design guidance. It is intended to help engineers locate the official MC9S12D64VPV documentation, understand the device's architectural limits, and determine whether a pin-compatible S12D family device is appropriate for an existing design.
RFQ
Contact