LM2904AN vs LM358AN Comparison
Detailed side-by-side comparison of LM2904AN by onsemi and LM358AN by Texas Instruments. Compare key specifications, electrical parameters, packaging, lifecycle status, pricing, and availability to determine the best component for your design requirements.
Texas Instruments
LM358AN - Dual 1MHz Op Amp, 3-36V Single Supply | Texas Instruments
LM358AN ✓ ActiveSpecification Comparison
| Parameter | LM2904AN | LM358AN |
|---|---|---|
| Brand | onsemi | Texas Instruments |
| Category | Amplifier ICs | Amplifier ICs |
| Lifecycle Status | Active | Active |
| Amplifier Type | Standard (General Purpose) | General-purpose, internally frequency-compensated, single-supply operational amplifier |
| Number of Circuits | 2 | — |
| Supply Voltage Range | 3 V to 26 V | — |
| Gain Bandwidth Product | 700 kHz (per TI LM2904 product page) | — |
| Single Supply Operation | Yes | — |
| Split Supply Operation | Yes | — |
| Input Common-Mode Range | Extends to ground/VEE | — |
| Power Drain | Low power (per onsemi datasheet) | — |
| Package | 8-PDIP (DIP-8) | PDIP-8, 8-pin plastic dual in-line (through-hole) |
| Mounting Type | Through Hole | Through-hole |
| Operating Temperature Range | [DATA_NEEDED: operating temperature range] | 0 C to +70 C |
| Input Offset Voltage | [DATA_NEEDED: input offset voltage] | 2 mV typical, 3 mV maximum |
| Slew Rate | [DATA_NEEDED: slew rate] | 0.3 V/us |
| Quiescent Current (per amplifier) | [DATA_NEEDED: quiescent current] | — |
| Output Current per Channel | [DATA_NEEDED: output current per channel] | — |
| Datasheet Length | 14 pages (137 Kbytes, onsemi datasheet) | — |
| Number of Amplifiers | — | 2 (independent channels) |
| Supply Voltage Range (single supply) | — | 3 V to 36 V |
| Maximum Total Supply Voltage | — | 36 V |
| Input Common-Mode Voltage Range | — | 0 V to (V+ minus 1.5 V) |
| Open-Loop Gain | — | 100 dB minimum |
| Gain-Bandwidth Product | — | 1.0 MHz |
| Input Bias Current | — | 20 nA typical |
| Input Offset Current | — | 2 nA typical |
| Output Current | — | 40 mA typical source, 20 mA typical sink |
| Output Voltage Swing | — | Approximately 20 mV from each rail into 2 kOhm load |
| Lead-Free Status | — | Lead-free (A suffix), RoHS compliant |
| Number of Outputs per IC | — | 2 |
| Current Supply (Typ) | — | [DATA_NEEDED: total supply current typical] |