LM2904AN vs LM358AN Comparaison
Comparaison détaillée côte à côte de LM2904AN par onsemi et LM358AN par Texas Instruments. Comparez les spécifications clés, les paramètres électriques, le conditionnement, le statut de cycle de vie, les prix et la disponibilité pour déterminer le meilleur composant pour vos exigences de conception.
Texas Instruments
LM358AN - Dual 1MHz Op Amp, 3-36V Single Supply | Texas Instruments
LM358AN ✓ ActifComparaison des spécifications
| Paramètre | LM2904AN | LM358AN |
|---|---|---|
| Marque | onsemi | Texas Instruments |
| Catégorie | Amplifier ICs | Amplifier ICs |
| Statut du cycle de vie | Actif | Actif |
| Amplifier Type | Standard (General Purpose) | General-purpose, internally frequency-compensated, single-supply operational amplifier |
| Number of Circuits | 2 | — |
| Supply Voltage Range | 3 V to 26 V | — |
| Gain Bandwidth Product | 700 kHz (per TI LM2904 product page) | — |
| Single Supply Operation | Yes | — |
| Split Supply Operation | Yes | — |
| Input Common-Mode Range | Extends to ground/VEE | — |
| Power Drain | Low power (per onsemi datasheet) | — |
| Boîtier | 8-PDIP (DIP-8) | PDIP-8, 8-pin plastic dual in-line (through-hole) |
| Type de montage | Through Hole | Through-hole |
| Plage de température de fonctionnement | [DATA_NEEDED: operating temperature range] | 0 C to +70 C |
| Input Offset Voltage | [DATA_NEEDED: input offset voltage] | 2 mV typical, 3 mV maximum |
| Slew Rate | [DATA_NEEDED: slew rate] | 0.3 V/us |
| Quiescent Current (per amplifier) | [DATA_NEEDED: quiescent current] | — |
| Output Current per Channel | [DATA_NEEDED: output current per channel] | — |
| Datasheet Length | 14 pages (137 Kbytes, onsemi datasheet) | — |
| Number of Amplifiers | — | 2 (independent channels) |
| Supply Voltage Range (single supply) | — | 3 V to 36 V |
| Maximum Total Supply Voltage | — | 36 V |
| Input Common-Mode Voltage Range | — | 0 V to (V+ minus 1.5 V) |
| Open-Loop Gain | — | 100 dB minimum |
| Gain-Bandwidth Product | — | 1.0 MHz |
| Input Bias Current | — | 20 nA typical |
| Input Offset Current | — | 2 nA typical |
| Output Current | — | 40 mA typical source, 20 mA typical sink |
| Output Voltage Swing | — | Approximately 20 mV from each rail into 2 kOhm load |
| Lead-Free Status | — | Lead-free (A suffix), RoHS compliant |
| Number of Outputs per IC | — | 2 |
| Current Supply (Typ) | — | [DATA_NEEDED: total supply current typical] |