LM2904AN vs LM358AN Comparación
Comparación detallada lado a lado de LM2904AN por onsemi y LM358AN por Texas Instruments. Compare las especificaciones clave, los parámetros eléctricos, el encapsulado, el estado del ciclo de vida, los precios y la disponibilidad para determinar el mejor componente para los requisitos de su diseño.
Texas Instruments
LM358AN - Dual 1MHz Op Amp, 3-36V Single Supply | Texas Instruments
LM358AN ✓ ActivoComparación de especificaciones
| Parámetro | LM2904AN | LM358AN |
|---|---|---|
| Marca | onsemi | Texas Instruments |
| Categoría | Amplifier ICs | Amplifier ICs |
| Estado del ciclo de vida | Activo | Activo |
| Amplifier Type | Standard (General Purpose) | General-purpose, internally frequency-compensated, single-supply operational amplifier |
| Number of Circuits | 2 | — |
| Supply Voltage Range | 3 V to 26 V | — |
| Gain Bandwidth Product | 700 kHz (per TI LM2904 product page) | — |
| Single Supply Operation | Yes | — |
| Split Supply Operation | Yes | — |
| Input Common-Mode Range | Extends to ground/VEE | — |
| Power Drain | Low power (per onsemi datasheet) | — |
| Encapsulado | 8-PDIP (DIP-8) | PDIP-8, 8-pin plastic dual in-line (through-hole) |
| Tipo de montaje | Through Hole | Through-hole |
| Rango de temperatura de funcionamiento | [DATA_NEEDED: operating temperature range] | 0 C to +70 C |
| Input Offset Voltage | [DATA_NEEDED: input offset voltage] | 2 mV typical, 3 mV maximum |
| Slew Rate | [DATA_NEEDED: slew rate] | 0.3 V/us |
| Quiescent Current (per amplifier) | [DATA_NEEDED: quiescent current] | — |
| Output Current per Channel | [DATA_NEEDED: output current per channel] | — |
| Datasheet Length | 14 pages (137 Kbytes, onsemi datasheet) | — |
| Number of Amplifiers | — | 2 (independent channels) |
| Supply Voltage Range (single supply) | — | 3 V to 36 V |
| Maximum Total Supply Voltage | — | 36 V |
| Input Common-Mode Voltage Range | — | 0 V to (V+ minus 1.5 V) |
| Open-Loop Gain | — | 100 dB minimum |
| Gain-Bandwidth Product | — | 1.0 MHz |
| Input Bias Current | — | 20 nA typical |
| Input Offset Current | — | 2 nA typical |
| Output Current | — | 40 mA typical source, 20 mA typical sink |
| Output Voltage Swing | — | Approximately 20 mV from each rail into 2 kOhm load |
| Lead-Free Status | — | Lead-free (A suffix), RoHS compliant |
| Number of Outputs per IC | — | 2 |
| Current Supply (Typ) | — | [DATA_NEEDED: total supply current typical] |