SN65HVD77D vs SN65HVD11D Comparison
Detailed side-by-side comparison of SN65HVD77D by Texas Instruments and SN65HVD11D by Texas Instruments. Compare key specifications, electrical parameters, packaging, lifecycle status, pricing, and availability to determine the best component for your design requirements.
Texas Instruments
SN65HVD77D - 3.3V 50Mbps Full-Duplex RS-485 | Texas Instruments
SN65HVD77D ✓ ActiveSpecification Comparison
| Parameter | SN65HVD77D | SN65HVD11D |
|---|---|---|
| Brand | Texas Instruments | Texas Instruments |
| Category | Interface ICs | Interface ICs |
| Lifecycle Status | Active | Active |
| Product Type | Full-duplex RS-485 transceiver | Differential transceiver |
| Supply Voltage Range | 3.0 V to 3.6 V | — |
| Nominal Supply Voltage | 3.3 V | — |
| Maximum Data Rate | 50 Mbps | — |
| Number of Drivers | 1 | — |
| Number of Receivers | 1 | — |
| Duplex Mode | Full duplex | — |
| Supported Standards | RS-485 and RS-422 | — |
| ESD Protection | ±12 kV IEC | — |
| Operating Temperature Range | -40°C to 125°C | — |
| Package | 8-pin SOIC (D) | 8-pin SOIC (D) |
| Package Width | 3.90 mm | — |
| Mounting Type | Surface mount | Surface mount |
| External Enable Controls | None | — |
| RoHS Status | Compliant | [DATA_NEEDED: RoHS status] |
| Driver Output Type | Differential | — |
| Receiver Output Type | Single-ended logic output | — |
| Low-Power Standby Current | Less than 5 µA when driver and receiver are disabled | — |
| Termination Requirement | External termination required | — |
| Supported Interfaces | — | RS-485 and RS-422 |
| Supply Voltage | — | 3.3 V |
| Driver Output State | — | Three-state |
| Receiver Architecture | — | Differential input |
| Unit Load | — | 1/8 unit load |
| Maximum Bus Nodes | — | Up to 256 nodes |
| Bus-Pin ESD Protection | — | Exceeds 16 kV HBM |
| Standards | — | ANSI TIA/EIA-485-A and ISO 8482:1993 |
| Operating Temperature | — | -40 °C to +85 °C |
| Pin Count | — | 8 pins |
| Output Current | — | [DATA_NEEDED: output current] |
| Data Rate | — | [DATA_NEEDED: maximum data rate] |
| Differential Output Voltage | — | [DATA_NEEDED: differential output voltage] |
| Receiver Differential Threshold | — | [DATA_NEEDED: receiver differential threshold] |
| Supply Current | — | [DATA_NEEDED: operating supply current] |
| REACH Status | — | [DATA_NEEDED: REACH status] |