EPC1441PI8N vs EPC1441PCB Vergleich
Detaillierter Direktvergleich von EPC1441PI8N von Altera und EPC1441PCB von Altera. Vergleichen Sie die wichtigsten Spezifikationen, elektrischen Parameter, Gehäuse, Lebenszyklusstatus, Preise und Verfügbarkeit, um das beste Bauteil für Ihre Designanforderungen zu ermitteln.
Altera
EPC1441PI8N - 440Kb OTP Config PROM, 8-PDIP | Altera / Intel
EPC1441PI8N ⚠ Letzte Bestellmöglichkeit
Spezifikationsvergleich
| Parameter | EPC1441PI8N | EPC1441PCB |
|---|---|---|
| Marke | Altera | Altera |
| Kategorie | Memory ICs | FPGA & CPLD |
| Lebenszyklusstatus | Letzte Kaufgelegenheit | Obsolete |
| Lagerstatus | In Stock | In Stock |
| Stückpreis (USD) | $3,55 | $2,18 |
| Speichertyp | OTP Configuration PROM (poly-fuse) | — |
| Memory Capacity | 440,800 bits (440 Kbit) | — |
| Configuration Interface | Altera Serial (PS) configuration | Altera serial/parallel configuration bus (nSTATUS, nCONFIG, DCLK, DATA) |
| Supply Voltage VCC | 5.0 V nominal (4.75 V to 5.25 V) | — |
| Active Supply Current ICC | [DATA_NEEDED: typical active ICC] | — |
| Standby Supply Current ICCSTBY | approximately 50 uA | — |
| Programming Method | Off-board PROM programmer (poly-fuse OTP) | — |
| Configuration Time | <100 ms typical for FLEX10KA loading | — |
| Betriebstemperatur | -40C to +85C (industrial) | 0 C to +70 C (commercial) |
| Gehäuse | 8-pin PDIP (Plastic DIP, through-hole) | PLCC-20 (Plastic Leaded Chip Carrier) |
| Pin-Anzahl | 8 | — |
| Montageart | Through-hole (THT) | Surface Mount / Socket |
| Lead-Free / RoHS | Non-RoHS (legacy through-hole); check suffix for Pb-free option | — |
| Compatible FPGA Families | FLEX10K, FLEX10KA, FLEX6000, APEX20K series | — |
| Family Position | Top-of-family (largest density: 440Kb) | — |
| Programming Voltage | [DATA_NEEDED: VPP programming voltage] | — |
| Endurance | One-time programmable (no reprogram cycles) | — |
| Device Type | — | Enhanced Configuration Device for SRAM FPGAs |
| Memory Density | — | 4,435,200 bits (~4 Mb) |
| Supported FPGA Families | — | ACEX 1K, APEX 20K, APEX II, FLEX 10K, FLEX 6000, FLEX 8000, Mercury |
| Programmability | — | In-system programmable via JTAG (IEEE 1149.1) |
| Supply Voltage (VCC) | — | 3.3 V nominal |
| I/O Voltage Tolerance | — | 5 V tolerant |
| Configuration Mode | — | Automatic at power-up |
| Architecture | — | Flash memory + on-chip configuration controller |
| JTAG Support | — | Yes (IEEE 1149.1 boundary scan) |
| RoHS-Status | — | [DATA_NEEDED: RoHS compliance status] |
| Lead-Free | — | [DATA_NEEDED: lead-free status] |