EPC1441PI8N vs EPC1441PCB Comparaison
Comparaison détaillée côte à côte de EPC1441PI8N par Altera et EPC1441PCB par Altera. Comparez les spécifications clés, les paramètres électriques, le conditionnement, le statut de cycle de vie, les prix et la disponibilité pour déterminer le meilleur composant pour vos exigences de conception.
Comparaison des spécifications
| Paramètre | EPC1441PI8N | EPC1441PCB |
|---|---|---|
| Marque | Altera | Altera |
| Catégorie | Memory ICs | FPGA & CPLD |
| Statut du cycle de vie | Dernier achat | Obsolete |
| Statut du stock | In Stock | In Stock |
| Prix unitaire (USD) | $3,55 | $2,18 |
| Type de mémoire | OTP Configuration PROM (poly-fuse) | — |
| Memory Capacity | 440,800 bits (440 Kbit) | — |
| Configuration Interface | Altera Serial (PS) configuration | Altera serial/parallel configuration bus (nSTATUS, nCONFIG, DCLK, DATA) |
| Supply Voltage VCC | 5.0 V nominal (4.75 V to 5.25 V) | — |
| Active Supply Current ICC | [DATA_NEEDED: typical active ICC] | — |
| Standby Supply Current ICCSTBY | approximately 50 uA | — |
| Programming Method | Off-board PROM programmer (poly-fuse OTP) | — |
| Configuration Time | <100 ms typical for FLEX10KA loading | — |
| Température de fonctionnement | -40C to +85C (industrial) | 0 C to +70 C (commercial) |
| Boîtier | 8-pin PDIP (Plastic DIP, through-hole) | PLCC-20 (Plastic Leaded Chip Carrier) |
| Nombre de broches | 8 | — |
| Type de montage | Through-hole (THT) | Surface Mount / Socket |
| Lead-Free / RoHS | Non-RoHS (legacy through-hole); check suffix for Pb-free option | — |
| Compatible FPGA Families | FLEX10K, FLEX10KA, FLEX6000, APEX20K series | — |
| Family Position | Top-of-family (largest density: 440Kb) | — |
| Programming Voltage | [DATA_NEEDED: VPP programming voltage] | — |
| Endurance | One-time programmable (no reprogram cycles) | — |
| Device Type | — | Enhanced Configuration Device for SRAM FPGAs |
| Memory Density | — | 4,435,200 bits (~4 Mb) |
| Supported FPGA Families | — | ACEX 1K, APEX 20K, APEX II, FLEX 10K, FLEX 6000, FLEX 8000, Mercury |
| Programmability | — | In-system programmable via JTAG (IEEE 1149.1) |
| Supply Voltage (VCC) | — | 3.3 V nominal |
| I/O Voltage Tolerance | — | 5 V tolerant |
| Configuration Mode | — | Automatic at power-up |
| Architecture | — | Flash memory + on-chip configuration controller |
| JTAG Support | — | Yes (IEEE 1149.1 boundary scan) |
| Statut RoHS | — | [DATA_NEEDED: RoHS compliance status] |
| Lead-Free | — | [DATA_NEEDED: lead-free status] |