EPC8QC100DM vs EPC8QC100 Comparación
Comparación detallada lado a lado de EPC8QC100DM por Intel y EPC8QC100 por Altera. Compare las especificaciones clave, los parámetros eléctricos, el encapsulado, el estado del ciclo de vida, los precios y la disponibilidad para determinar el mejor componente para los requisitos de su diseño.
Comparación de especificaciones
| Parámetro | EPC8QC100DM | EPC8QC100 |
|---|---|---|
| Marca | Intel | Altera |
| Categoría | EEPROM | Memory ICs |
| Estado del ciclo de vida | Obsolete | Obsolete |
| Estado del stock | In Stock | In Stock |
| Precio unitario (USD) | $17,10 | $17,50 |
| Tipo de memoria | Non-volatile configuration PROM | Configuration PROM (Flash-based) |
| Tamaño de memoria | 8 Mb (1 MB) | 8 Mbit |
| Interfaz | Serial (Passive Serial / Passive Parallel Synchronous / Active Serial) | — |
| Supply Voltage (VCC) | 3.0 V to 3.6 V (3.3 V typical) | — |
| Maximum DCLK Frequency | 40 MHz | — |
| In-System Programming | Yes (IEEE 1149.1 / IEEE 1532 JTAG) | — |
| Cascade Support | Yes - two EPC8 devices for 16 Mb | — |
| Temperatura de funcionamiento | -40 C to +85 C (industrial / DM suffix) | 0C to +70C (Commercial) |
| Encapsulado | 100-PQFP (20 x 14 mm) | 100-Pin PQFP (20 x 14 mm) |
| Tipo de montaje | Surface Mount | Surface Mount |
| Nivel MSL | 1 (Unlimited) | — |
| Estado RoHS | Compliant | [DATA_NEEDED: RoHS compliance] |
| Lead-Free / Halogen-Free | Lead-free (per supplier); halogen status not in datasheet excerpt | — |
| Compatible FPGA Families | Cyclone, Cyclone II, Cyclone III, Stratix, Arria | Stratix, APEX II, APEX 20K, Mercury, ACEX 1K, FLEX 10K |
| Configuration Modes | PS, PPS, AS (with appropriate FPGA master) | — |
| Programming Cycles | [DATA_NEEDED: minimum erase/write endurance cycles] | — |
| Flash Access Time | — | 90 ns (~10 MHz) |
| Configuration Bus Width | — | 16-bit (DQ[]) |
| Configuration Bandwidth | — | Up to 160 Mbps |
| Decompression Support | — | Yes (Altera proprietary) |
| Supported Configuration Modes | — | FPP, PS, AS (FPGA-dependent) |
| ISP Interface | — | JTAG (IEEE 1149.1) |
| Tensión de alimentación | — | 3.3 V |
| Lead Free | — | [DATA_NEEDED: lead-free status] |