EPC8QC100DM vs EPC8QC100 Comparaison
Comparaison détaillée côte à côte de EPC8QC100DM par Intel et EPC8QC100 par Altera. Comparez les spécifications clés, les paramètres électriques, le conditionnement, le statut de cycle de vie, les prix et la disponibilité pour déterminer le meilleur composant pour vos exigences de conception.
Comparaison des spécifications
| Paramètre | EPC8QC100DM | EPC8QC100 |
|---|---|---|
| Marque | Intel | Altera |
| Catégorie | EEPROM | Memory ICs |
| Statut du cycle de vie | Obsolete | Obsolete |
| Statut du stock | In Stock | In Stock |
| Prix unitaire (USD) | $17,10 | $17,50 |
| Type de mémoire | Non-volatile configuration PROM | Configuration PROM (Flash-based) |
| Taille de mémoire | 8 Mb (1 MB) | 8 Mbit |
| Interface | Serial (Passive Serial / Passive Parallel Synchronous / Active Serial) | — |
| Supply Voltage (VCC) | 3.0 V to 3.6 V (3.3 V typical) | — |
| Maximum DCLK Frequency | 40 MHz | — |
| In-System Programming | Yes (IEEE 1149.1 / IEEE 1532 JTAG) | — |
| Cascade Support | Yes - two EPC8 devices for 16 Mb | — |
| Température de fonctionnement | -40 C to +85 C (industrial / DM suffix) | 0C to +70C (Commercial) |
| Boîtier | 100-PQFP (20 x 14 mm) | 100-Pin PQFP (20 x 14 mm) |
| Type de montage | Surface Mount | Surface Mount |
| Niveau MSL | 1 (Unlimited) | — |
| Statut RoHS | Compliant | [DATA_NEEDED: RoHS compliance] |
| Lead-Free / Halogen-Free | Lead-free (per supplier); halogen status not in datasheet excerpt | — |
| Compatible FPGA Families | Cyclone, Cyclone II, Cyclone III, Stratix, Arria | Stratix, APEX II, APEX 20K, Mercury, ACEX 1K, FLEX 10K |
| Configuration Modes | PS, PPS, AS (with appropriate FPGA master) | — |
| Programming Cycles | [DATA_NEEDED: minimum erase/write endurance cycles] | — |
| Flash Access Time | — | 90 ns (~10 MHz) |
| Configuration Bus Width | — | 16-bit (DQ[]) |
| Configuration Bandwidth | — | Up to 160 Mbps |
| Decompression Support | — | Yes (Altera proprietary) |
| Supported Configuration Modes | — | FPP, PS, AS (FPGA-dependent) |
| ISP Interface | — | JTAG (IEEE 1149.1) |
| Tension d'alimentation | — | 3.3 V |
| Lead Free | — | [DATA_NEEDED: lead-free status] |