ADM233LJN vs ADM233LJNZ Comparaison
Comparaison détaillée côte à côte de ADM233LJN par Analog Devices et ADM233LJNZ par Analog Devices. Comparez les spécifications clés, les paramètres électriques, le conditionnement, le statut de cycle de vie, les prix et la disponibilité pour déterminer le meilleur composant pour vos exigences de conception.
Comparaison des spécifications
| Paramètre | ADM233LJN | ADM233LJNZ |
|---|---|---|
| Marque | Analog Devices | Analog Devices |
| Catégorie | Interface ICs | Interface ICs |
| Statut du cycle de vie | Actif | Actif |
| Tension d'alimentation | 5 V | 5 V |
| Interface Standard | RS-232 | V.28 |
| Transceiver Configuration | 2 driver and 2 receiver channels | — |
| Maximum Data Rate | 120 kbit/s | 120 kbps |
| Output Swing | ±9 V | — |
| Charge-Pump Capacitor Value | 1 µF | — |
| DC-DC Converter | On-board | — |
| Receiver Input Voltage Rating | 30 V | — |
| Receiver Shutdown Behavior | Receivers remain active during shutdown | — |
| Power-Saving Mode | Low-power shutdown | — |
| Compliance Standard | EIA-232-E and V.28 | — |
| Boîtier | 20-pin PDIP | 20-pin PDIP |
| Type de montage | Through-hole | Through-hole |
| Logic Supply Level | 5 V CMOS | — |
| Statut RoHS | [DATA_NEEDED: RoHS status] | [DATA_NEEDED: RoHS status] |
| REACH Status | [DATA_NEEDED: REACH status] | [DATA_NEEDED: REACH status] |
| AEC-Q100 Qualification | [DATA_NEEDED: AEC-Q100 qualification] | — |
| Plage de température de fonctionnement | [DATA_NEEDED: operating temperature range] | [DATA_NEEDED: operating temperature range] |
| Device Type | — | 2/2 RS-232 line transceiver |
| Number of Drivers | — | 2 |
| Number of Receivers | — | 2 |
| RS-232 Output Swing | — | Approximately ±9 V |
| External Capacitor Value | — | 1 µF |
| Package Pin Count | — | 20 pins |
| Integrated DC-DC Converters | — | On-board |
| External Power-Supply Requirement | — | No external ±12 V supply |
| Courant d'alimentation | — | [DATA_NEEDED: supply current] |
| Driver Output Voltage | — | [DATA_NEEDED: driver output voltage] |
| Receiver Input Threshold | — | [DATA_NEEDED: receiver input threshold] |