KSZ8041NL-AM vs KSZ8041TL Comparaison
Comparaison détaillée côte à côte de KSZ8041NL-AM par Microchip Technology et KSZ8041TL par Microchip Technology. Comparez les spécifications clés, les paramètres électriques, le conditionnement, le statut de cycle de vie, les prix et la disponibilité pour déterminer le meilleur composant pour vos exigences de conception.
Comparaison des spécifications
| Paramètre | KSZ8041NL-AM | KSZ8041TL |
|---|---|---|
| Marque | Microchip Technology | Microchip Technology |
| Catégorie | RF Transceivers | Interface ICs |
| Statut du cycle de vie | Actif | Actif |
| Fonction | 10BASE-T/100BASE-TX Ethernet PHY transceiver | — |
| Interface | MII / RMII | — |
| Number of Ports | 1 (1/1 Transceiver, Full) | — |
| Débit de données | 10 Mbps / 100 Mbps | — |
| Tension d'alimentation | 3.3 V (single supply) | [DATA_NEEDED: supply voltage range] |
| Auto MDI/MDI-X | Yes (HP Auto MDI/MDI-X) | — |
| Auto-Negotiation | Yes | — |
| Boîtier | 32-QFN (5x5 mm) with exposed pad | 48-TQFP (7 x 7 mm) |
| Type de montage | Surface Mount | Surface mount |
| Température de fonctionnement | -40C to +85C | [DATA_NEEDED: operating temperature range] |
| Crystal Reference | 25 MHz | — |
| RMII Clock (50 MHz) | External clock source required (per KSZ8041NL design) | — |
| Signaling Distance | Extended (mixed-signal design, per datasheet) | — |
| Niveau MSL | [DATA_NEEDED: MSL rating] | — |
| Power Consumption | Low-power mixed-signal design (per datasheet); [DATA_NEEDED: typical mA value] | — |
| Statut RoHS | Compliant | [DATA_NEEDED: RoHS status] |
| Datasheet Document | KSZ8041NL/RNL Data Sheet (Microchip DS00002245B) | — |
| Product Type | — | 10BASE-T/100BASE-TX Ethernet physical-layer transceiver |
| Supported Data Rates | — | 10 Mb/s and 100 Mb/s |
| Host Interfaces | — | MII, RMII, and SMII |
| Supply Architecture | — | Single-supply |
| Cable Standard | — | 10BASE-T and 100BASE-TX |
| Mixed-Signal Design | — | Yes; intended to extend signaling distance while reducing power consumption |
| Auto MDI/MDIX | — | HP Auto MDI/MDIX |
| Interrupt Signal | — | INTRP on pin 32; optional PHY-register status-update signal |
| Number of Drivers/Receivers | — | 1 driver and 1 receiver |
| Device Type | — | Ethernet interface IC / physical-layer transceiver |
| Interface Clock | — | [DATA_NEEDED: clock frequency] |
| Ethernet Magnetics | — | [DATA_NEEDED: supported magnetics and isolation configuration] |
| REACH Status | — | [DATA_NEEDED: REACH status] |
| Automotive Qualification | — | [DATA_NEEDED: AEC-Q100 qualification] |